Pakikipagtulungan
SINING
BEAUTY AT WELLNESS
CRAFTS
KULTURA AT KASAYSAYAN
LIBANGAN
KAPALIGIRAN
PAGKAIN AT INUMIN
REVERSE ENGINEERING
AGHAM
ISPORTS
TEKNOLOHIYA
MGA WEARABLE
Protractor: Plain Circular Brass Protractor with a Centre Bar (Stanley, 1878)
The draughtsman's circular protractor: a flat brass ring divided all round into degrees and half-degrees, its outer edge bevelled thin so a needle point can feel the divisions, with a bar across the middle whose edge runs exactly through the centre from 0° to 180°. Lay the bar on a line, prick off the angle and draw through the point and the centre.
Result: a protractor for setting off and measuring angles on a drawing.
Source: W. F. Stanley, A Descriptive Treatise on Mathematical Drawing Instruments (1878), pp. 227-228. Unknown: sizes and how the circle is divided. Picture: the book's figure.
Katamtaman
Unknown
Mga Tagubilin
1
1
Make the ring and bar
Make the ring and bar
Cut a flat ring of brass (electrum also serves) with a bar across the inner space. Make one side of the bar a true straight line through the centre of the ring, and mark the centre with a short line in the middle of the bar; a small semicircle may be cut out of the bar's edge there to make it easier to set over a point. Bevel the outer edge down very thin. Not given: sizes. Ours: brass sheet.
Mga materyales para sa hakbang na ito:
Lapad na Bronse1 ring and barMga kailangang kasangkapan:
Gunting na pangyero
Torno para sa Metal
Hindi alam na sukat2
2
Divide it
Divide it
Divide the circumference into degrees, subdivided into half-degrees, so that the bar's edge, carried on, reads 0° and 180°, and number the degrees. Not given: how the circle is divided.
Mga kailangang kasangkapan:
Hindi alam na sukat3
3
Use it
Use it
To set off an angle from a point on a line, lay the bar so it half covers the line, the line reading 0 to 180, with the point in the centre. Prick off the number of degrees at the bevelled edge with a needle point, lift the protractor away, and draw a line through the mark and the point.
Mga kailangang kasangkapan:
Hindi alam na sukatMga Materyales
1- 1 ring and barPlaceholder
Mga Kinakailangang Kasangkapan
3- Placeholder
- Placeholder
- Placeholder
Ang blueprint na ito ay gumagawa ng
CC0 Pampublikong Domain
Ang blueprint na ito ay inilabas sa ilalim ng CC0. Malaya kang kumopya, magbago, mamahagi, at gumamit nang walang pahintulot.
Suportahan ang Maker sa pamamagitan ng pagbili ng mga produkto sa kanilang Blueprint Komisyon ng Maker itinakda ng mga Vendor, o lumikha ng bagong bersyon ng Blueprint na ito at isama bilang koneksyon sa iyong Blueprint upang ibahagi ang kita.