SINING
BEAUTY AT WELLNESS
CRAFTS
KULTURA AT KASAYSAYAN
LIBANGAN
KAPALIGIRAN
PAGKAIN AT INUMIN
REVERSE ENGINEERING
AGHAM
ISPORTS
TEKNOLOHIYA
MGA WEARABLE
Wool Cloth Woven in Plain Weave on a Rigid Heddle Loom
Plain weave is the most basic weave: each weft thread goes over one warp thread and under the next. Woven from undyed wool yarn, the cloth comes off the loom loose and soft, still oily and unshrunk; fulling cleans and thickens it afterwards.
The picture: plain weave seen close up.
Baguhan
A few days
Mga Tagubilin
1
1
Warp the loom
Warp the loom
Measure the warp (step 5), tie it to the front roller, and thread one end through each slot and each hole of the heddle. Wind it on the back roller under even tension.
Mga materyales para sa hakbang na ito:
Sinulid na pang-lalagyan320 mMga kailangang kasangkapan:
Habihang may matigas na suklay
Ruler
Klamp na hugis-C
Gunting2
2
Weave
Weave
Lift the heddle, pass the shuttle through, lower the heddle and pass it back, beating each pick in lightly with the heddle. Lay the weft in at a slant so the edges do not draw in.
Mga materyales para sa hakbang na ito:
Sinulid na pahalang265 mMga kailangang kasangkapan:
Habihang may matigas na suklay
Lansadera3
3
Advance and keep going
Advance and keep going
Wind the woven cloth onto the front roller as you go, keeping the beat even so the cloth has the same number of picks per cm all along.
Mga kailangang kasangkapan:
Habihang may matigas na suklayRuler4
4
Cut off
Cut off
Weave to the end of the warp, cut the cloth off, and knot the warp ends in groups so the weft cannot unravel. It is now loom-state cloth, ready for fulling.
Mga kailangang kasangkapan:
Gunting5
5
Yarn for the cloth
Yarn for the cloth
Naglo-load ng Jupyter notebook…
Mga Materyales
2- Placeholder
- 265 mPlaceholder
Ang blueprint na ito ay gumagawa ng
Kaugnay na Blueprint
Ang mga blueprint na ito ay nagbabahagi ng kaalaman — mga teknik, materyales, o prinsipyo
CC0 Pampublikong Domain
Ang blueprint na ito ay inilabas sa ilalim ng CC0. Malaya kang kumopya, magbago, mamahagi, at gumamit nang walang pahintulot.
Suportahan ang Maker sa pamamagitan ng pagbili ng mga produkto sa kanilang Blueprint Komisyon ng Maker itinakda ng mga Vendor, o lumikha ng bagong bersyon ng Blueprint na ito at isama bilang koneksyon sa iyong Blueprint upang ibahagi ang kita.