فن
خوبصورتی اور تندرستی
دستکاری
ثقافت اور تاریخ
تفریح
ماحول
خوراک اور مشروبات
ریورس انجینئرنگ
سائنسز
کھیل
ٹیکنالوجی
پہننے والے آلات
Getting the Solid Back: Evaporate, Crystallise, and Dry to Constant Mass
Charlie

تخلیق کار

Charlie

24. ستمبر 2026DE
23
0
0
0
0

Getting the Solid Back: Evaporate, Crystallise, and Dry to Constant Mass

Boiling a solution dry gives you everything that was dissolved in it, including the impurities. Letting it crystallise slowly gives you the substance you wanted and leaves most of the impurities in the liquid — because a growing crystal is fussy about what it lets in. So evaporating to dryness and crystallising are not two ways of doing the same job. The first is for recovering everything; the second is for purifying. Then there is the question of when it is actually DRY, which cannot be answered by looking. The answer is a measurement loop: dry, weigh, dry again, weigh again, and stop when the mass stops changing.
درمیانہ
3 hours

ہدایات

1

Evaporate gently, and never to the last drop over heat

Use a wide, shallow evaporating dish rather than a beaker: evaporation happens at the surface, so the area is what sets the speed, and a wide dish is faster at a much lower temperature. Stop while a little liquid remains and let the rest go at room temperature. Once the liquid is nearly gone there is nothing left to absorb the heat, the solid overheats in seconds, and it spits, decomposes or bakes onto the dish. A steam bath or a hot plate on a low setting is better than a flame for anything that matters. Direct flame heats one spot far above the boiling point of the solution, and many substances that survive 100 degrees do not survive that.

اس مرحلے کے لیے مواد:

کشید کیا ہوا پانیکشید کیا ہوا پانی1 لیٹر
سوڈیم کلورائیڈ (نمک)سوڈیم کلورائیڈ (نمک)1 ٹکڑا

درکار اوزار:

تبخیر کی طشتریتبخیر کی طشتری
گرم پلیٹگرم پلیٹ
گھڑی کا شیشہگھڑی کا شیشہ
2

Crystallise slowly, and crystallise on purpose

Dissolve the solid in the smallest volume of hot solvent that will take it, then let it cool UNDISTURBED. Slow cooling grows few, large, pure crystals; rapid cooling or stirring gives a mass of tiny ones that trap the mother liquor and everything dissolved in it. If nothing appears, it is usually because there is too much solvent or because there is no nucleus to start on. Boil a little solvent off, scratch the inside of the glass with a rod at the surface, or add one seed crystal. Then filter the crystals off cold and rinse them with a SMALL amount of ICE-COLD solvent. Rinsing with warm solvent dissolves the product you just spent an hour growing, which is the most disheartening way to lose a yield.

اس مرحلے کے لیے مواد:

کشید کیا ہوا پانیکشید کیا ہوا پانی1 لیٹر
کاپر سلفیٹ پنج آبی (CuSO4·5H2O)کاپر سلفیٹ پنج آبی (CuSO4·5H2O)1 ٹکڑا

درکار اوزار:

شیشے کا بیکرشیشے کا بیکر
شیشے کی ہلانے والی سلاخشیشے کی ہلانے والی سلاخ
بوخنر قیف (چینی مٹی)بوخنر قیف (چینی مٹی)
چھاننے کا کاغذچھاننے کا کاغذ
3

Dry to constant mass, which is a measurement not a judgement

Jupyter نوٹ بک لوڈ ہو رہی ہے…

اس مرحلے کے لیے مواد:

سوڈیم کلورائیڈ (نمک)سوڈیم کلورائیڈ (نمک)1 ٹکڑا

درکار اوزار:

سُکھانے کا تنورسُکھانے کا تنور
شیشے کا خشک کار برتنشیشے کا خشک کار برتن
باریک ترازوباریک ترازو
ڈیسک ٹاپ کمپیوٹرڈیسک ٹاپ کمپیوٹر
4

Work out the yield, and be honest about it

Percentage yield is what you got divided by what the equation says you could have got. Both numbers have to be real: the mass actually recovered and dried, and the theoretical mass calculated from the LIMITING reagent. Yields above 100% mean the product is not dry, or it has picked up something. That is worth treating as a fault rather than a bonus, because a wet product weighs more and is worth less. Record where the losses went, in the notebook: left in the mother liquor, stuck to the filter paper, lost in the rinse, spilled. Those lines are what make the next attempt better, and a yield with no explanation attached is a number nobody can improve.

درکار اوزار:

باریک ترازوباریک ترازو
حساب کرنے والا آلہحساب کرنے والا آلہ

مواد

3

درکار اوزار

12

CC0 پبلک ڈومین

یہ بلیو پرنٹ CC0 کے تحت جاری کیا گیا ہے۔ آپ اجازت لیے بغیر اس کام کو نقل، ترمیم، تقسیم اور کسی بھی مقصد کے لیے استعمال کرنے کے لیے آزاد ہیں۔

میکر کی حمایت کریں ان کے بلیو پرنٹ کے ذریعے پروڈکٹس خرید کر جہاں وہ میکر کمیشن وینڈرز کی طرف سے مقرر، کماتے ہیں، یا اس بلیو پرنٹ کی نئی تکرار بنائیں اور آمدنی شیئر کرنے کے لیے اسے اپنے بلیو پرنٹ میں کنکشن کے طور پر شامل کریں۔

بحث

(0)

لاگ ان بحث میں شامل ہونے کے لیے

تبصرے لوڈ ہو رہے ہیں...