تعاون
فن
خوبصورتی اور تندرستی
دستکاری
ثقافت اور تاریخ
تفریح
ماحول
خوراک اور مشروبات
ریورس انجینئرنگ
سائنسز
کھیل
ٹیکنالوجی
پہننے والے آلات

Woven Collection Basket: the Oval Willow Linen Basket (Hasluck, 1903)
A large woven willow basket with a handle at each end, for carrying linen or gathered goods: the basket-maker's oval linen basket, with a crowned oval bottom woven on a tied 'slarth', stakes pushed in round it, randed sides 7 in deep at the ends and 2 1/2 in higher at the sides, a wale and a plaited border. About 22 in long.
Variable: randed (16 pairs of stakes) or slewed (15 1/2 pairs).
Source: Paul N. Hasluck, Basket Work of All Kinds (1903), pp. 55-63. Picture: Fig. 58 of the book.
اعلیٰ
Unknown
ہدایات
1
1
Cut the bottom sticks
Cut the bottom sticks
For a 14 in bottom cut seven sticks about 12 in long, shaving a little off along the middle, and an 8 in piece of rod to divide the tie-rods. Take eight tie-rods. Up to 14 in use three lays of sticks; larger bottoms need four and thicker sticks.
اس مرحلے کے لیے مواد:
موٹی بید کی چھڑیاں7 12 in
بید کی چھڑی8 tie-rodsدرکار اوزار:
کانٹ چھانٹ کی قینچی2
2
Tie the slarth
Tie the slarth
On the board, put four tie-rods' butts under the right foot. About 5 in from the ends lay two sticks between A and C and between B and D, then three sticks about 2 3/4 in further on, then the last two, so the three lays fill a 7 in space; slip the 8 in piece under the three middle sticks (Fig. 57). Work the other four rods between the sticks with butts the opposite way (Fig. 58), passing each tightly over and under, tapping them close with the iron and pulling up the sticks each time to crown the bottom. Lay the slarth about half the finished length.
درکار اوزار:
چپٹا لکڑی کا تختہ
ہتھوڑا3
3
Open the sticks and pair the bottom
Open the sticks and pair the bottom
Work the tie-rod tops round in pairs, opening the sticks into separate groups. Point a handful of rods at the butt, wet the points, and pair them in, thinnest and shortest first, one rod under and over the other, starting at either side, until the bottom is 14 in long. Finish the last pair in and out of the pairing, pick off the ends and cut off the stick ends with the shears.
اس مرحلے کے لیے مواد:
بید کی چھڑی1 pairing rodsدرکار اوزار:
کانٹ چھانٹ کی قینچی
بڑی قینچی
پانی4
4
Stake up and upset
Stake up and upset
Cut stakes as for a round basket: 16 pairs for a randed basket, 15 1/2 for a slewed one. Push them in, a pair beside each stick, turn the bottom over and press it down, prick up each stake and gather them in a large hoop; drive them in close. Upset with four rods, each in front of three stakes and behind the fourth, and add a second round.
اس مرحلے کے لیے مواد:
بید کے کھونٹے32 16 pairs
بید کی چھڑی1 upsettingدرکار اوزار:
فیتہ پرونے والی سوئی
کانٹ چھانٹ کی قینچی
ہتھوڑا5
5
Rand the sides and wale
Rand the sides and wale
Free the end stakes from the hoop: the top needs a good 8 in spring from end to end. Work a few short pieces at each side first, ends left outside so the inside stays smooth, then rand round to the right until the ends are 7 in high and the basket measures 22 in end to end. Raise the sides about 2 1/2 in higher than the ends. Work a wale of three rods (inside two stakes, outside one) or four (inside two, outside two).
اس مرحلے کے لیے مواد:
بید کی چھڑی1 randing, waleدرکار اوزار:
ہتھوڑا
پانی6
6
Border and handles
Border and handles
Begin the border by laying down five rods, each worked in front of four stakes and behind two; finish by cramming and trim with the picking knife. For each end handle push in two rods beside stakes three or four apart; bend one into a bow under the border, twist the other rope-fashion and lap it over the bow three times each way, then lap the bow rod's own top across it.
اس مرحلے کے لیے مواد:
بید کی چھڑی9 5 border rods, 4 handle rodsدرکار اوزار:
فیتہ پرونے والی سوئی
کانٹ چھانٹ کی قینچیمواد
3- 7 12 inپلیس ہولڈر
- 9 5 border rods, 4 handle rodsپلیس ہولڈر
- 32 16 pairsپلیس ہولڈر
یہ بلوپرنٹ بناتا ہے
CC0 پبلک ڈومین
یہ بلیو پرنٹ CC0 کے تحت جاری کیا گیا ہے۔ آپ اجازت لیے بغیر اس کام کو نقل، ترمیم، تقسیم اور کسی بھی مقصد کے لیے استعمال کرنے کے لیے آزاد ہیں۔
میکر کی حمایت کریں ان کے بلیو پرنٹ کے ذریعے پروڈکٹس خرید کر جہاں وہ میکر کمیشن وینڈرز کی طرف سے مقرر، کماتے ہیں، یا اس بلیو پرنٹ کی نئی تکرار بنائیں اور آمدنی شیئر کرنے کے لیے اسے اپنے بلیو پرنٹ میں کنکشن کے طور پر شامل کریں۔
