SZTUKA
Piękno i dobre samopoczucie
RZEMIOSŁO
KULTURA I HISTORIA
ROZRYWKA
ŚRODOWISKO
JEDZENIE I NAPOJE
INŻYNIERIA ODWROTNA
NAUKI
LEKKOATLETYKA
TECHNOLOGIA
URZĄDZENIA DO NOSZENIA

Building a Sheng — The Chinese Free-Reed Mouth Organ
Build a sheng: a cluster of bamboo pipes rising from a wind chamber, each voiced by a tiny springy free reed. Cover a pipe's finger hole and it sings; cover several and it plays a chord — and it sounds on both blow and draw. A serious maker build in the free reed, the mechanism the harmonica and accordion were born from.
Średniozaawansowany
Several hours over a few sessions
Instrukcje
1
1
A gourd full of singing bamboo
A gourd full of singing bamboo
The sheng is a mouth organ: a bundle of bamboo pipes standing in a wind chamber, each voiced by a tiny springy reed. It is the world's first free-reed instrument and the ancestor of the harmonica and accordion — and it can play chords.
2
2
Make the wind chamber
Make the wind chamber
Hollow a dried bottle gourd into an airtight air-chamber and fit a short mouthpiece tube into its neck to blow through. Early sheng used a gourd just like this.
Materiały do tego kroku:
Mature Bottle Gourd1 sztukaTools needed:
Sloyd Carving Knife3
3
Cut the pipes
Cut the pipes
Cut several thin bamboo pipes of different lengths. Start with five or six — enough for a small scale or a couple of chords.
Materiały do tego kroku:
Bamboo1 sztukaTools needed:
Hacksaw4
4
Cut a reed window in each pipe
Cut a reed window in each pipe
Near the bottom of each pipe cut a small, clean rectangular window. The free reed will sit over this window.
Tools needed:
Sloyd Carving Knife5
5
Cut the free reeds
Cut the free reeds
From thin brass, cut a tiny tongue that ALMOST fills a matching slot — fixed at one end, free at the other, with a hair-fine gap all around so it can swing cleanly through.
Materiały do tego kroku:
Brass Shim (Reed Stock)1 sztukaTools needed:
Metal File6
6
Fit a reed to each pipe
Fit a reed to each pipe
Seal a reed over each pipe's window with wax, airtight, with the free tongue facing inward toward the chamber.
Materiały do tego kroku:
Beeswax Pellets1 sztuka7
7
Cut a finger hole in each pipe
Cut a finger hole in each pipe
Cut one finger hole in the side of each pipe. This little hole is the on/off switch for that pipe's note.
Tools needed:
Awl8
8
Seat the pipes airtight
Seat the pipes airtight
Push the pipes down into the top of the chamber and seal each with wax so NO air can leak except through the reeds themselves.
Materiały do tego kroku:
Beeswax Pellets1 sztuka9
9
Test one pipe
Test one pipe
Blow gently into the mouthpiece and cover one pipe's finger hole. Covering the hole forces the air through that pipe's reed, and the reed sings out.
10
10
The finger-hole switch
The finger-hole switch
With the hole OPEN, air just escapes and the reed stays silent. COVER the hole and the pipe sounds. That is how you pick out notes on a sheng.
11
11
Tune the reeds
Tune the reeds
Add a dab of wax to a reed's tip to LOWER its pitch, or file the tip thinner to RAISE it, until every pipe is in tune. The reed sets the pitch, not the pipe length.
Materiały do tego kroku:
Beeswax Pellets1 sztukaTools needed:
Metal File12
12
Play a chord
Play a chord
Cover several finger holes at once and blow. The sheng sounds them all together as a chord — something almost no other wind instrument can do.
13
13
Blow and draw
Blow and draw
Now breathe IN through the mouthpiece. Free reeds sound on both blow and draw — the very trick the harmonica borrowed from the sheng.
14
14
Compendium — the free reed
Compendium — the free reed
The sheng is built on the free reed: a thin springy tongue that vibrates freely back and forth THROUGH a close-fitting slot, instead of slapping shut against a frame like the beating reed of a clarinet or the buzzing lips of a horn. Air flowing past the tongue sets it swinging in and out of the slot, chopping the airflow into a steady tone at the tongue's own pitch — and because the tongue passes cleanly through the gap, it speaks equally well whether you blow or draw, which is why the sheng and its child the harmonica both play in and out. Each reed is paired with a pipe whose air column reinforces it, and the finger hole is a switch: only when the hole is covered is the air forced through the reed, so a player can pick out notes, and several at once, giving the sheng its rare power to play chords. Pitch is set by the reed's length, thickness and a tuning dab of wax — not by the pipe's length. The sheng has been played in China for some three thousand years, and when examples reached Europe around 1800 they sparked a whole family of Western instruments: the harmonica, accordion, concertina, harmonium and reed organ all descend from this gourd full of singing bamboo. Its distant cousin is the jaw harp, whose plucked springy tongue is the same free-vibrating idea, driven by a finger instead of by breath.
Materiały
4- 1 sztukaPlaceholder
- 1 sztukaPlaceholder
- 3 sztukPlaceholder
Powiązane blueprinty
Te blueprinty dzielą się wiedzą — technikami, materiałami lub zasadami
CC0 Domena publiczna
Ten plan jest udostępniany na licencji CC0. Możesz go swobodnie kopiować, modyfikować, rozpowszechniać i wykorzystywać do dowolnych celów, bez konieczności uzyskiwania zgody.
Wesprzyj Makera kupując produkty przez jego plan, za co zarabia Prowizja Makera ustalony przez sprzedawców, lub stwórz nową iterację tego planu i dołącz go jako połączenie w swoim własnym planie, aby dzielić się przychodami.

