Współpraca
SZTUKA
Piękno i dobre samopoczucie
RZEMIOSŁO
KULTURA I HISTORIA
ROZRYWKA
ŚRODOWISKO
JEDZENIE I NAPOJE
INŻYNIERIA ODWROTNA
NAUKI
LEKKOATLETYKA
TECHNOLOGIA
URZĄDZENIA DO NOSZENIA
Clamping Caul: Plain Pine Board Shaped to the Work (Adamson, 1889)
Woody

Autor

Woody

9. listopad 2026NO
11
0
0
0
0

Clamping Caul: Plain Pine Board Shaped to the Work (Adamson, 1889)

A caul is a board laid over glued work so the clamps press evenly over the whole surface instead of only under their jaws. D. Adamson (1889) uses a piece of good sound pine about 1 in. thick, shaped exactly to fit the surface: flat for a flat panel, convex for a concave one. For veneering he warms it first. Wood can warp or twist, and burns if overheated; a zinc-faced caul (separate blueprint) lasts longer. Source: D. Adamson, "Practical Veneering", Work, 5 October 1889, pp. 453-455.
Początkujący
Unknown

Instrukcje

1

Read Adamson

"The caul itself is either wood or metal, either of which must be shaped exactly to fit the surface to be veneered. Thus for a flat panel it must be flat, while for a concave surface it must be convex, and so on. ... For the material nothing is more suitable than good sound pine."
2

Cut the board

Cut a piece of good sound pine about 1 in. thick, large enough to cover the whole surface to be pressed. Thicker is no better, only waste. The length and width are set by the work (not given).

Materiały do tego kroku:

Deska sosnowaDeska sosnowa1 about 1 in. thick

Potrzebne narzędzia:

Piła stolarskaPiła stolarska
Nieznane wymiaryNieznane wymiary
3

Shape it to the work

Plane the face that meets the work to fit it exactly: flat for a flat panel, convex for a concave surface. A caul that is hollow in the middle presses only at the edges. How it is trued is not given (ours: plane, checked with a straightedge).

Potrzebne narzędzia:

Strug ręcznyStrug ręczny
Liniał krawędziowyLiniał krawędziowy
4

Use it

Warm the caul (not so hot that it cannot be comfortably handled), lay it over the veneer with a sheet of slightly greased paper between, and screw down the hand-screws evenly until the glue oozes out at the edges. Leave it until the caul is cold, an hour or two.

Potrzebne narzędzia:

ŚciskiŚciski

Materiały

1
  • 1 about 1 in. thick
    Zastępnik

Wymagane narzędzia

5

CC0 Domena publiczna

Ten plan jest udostępniany na licencji CC0. Możesz go swobodnie kopiować, modyfikować, rozpowszechniać i wykorzystywać do dowolnych celów, bez konieczności uzyskiwania zgody.

Wesprzyj Makera kupując produkty przez jego plan, za co zarabia Prowizja Makera ustalony przez sprzedawców, lub stwórz nową iterację tego planu i dołącz go jako połączenie w swoim własnym planie, aby dzielić się przychodami.

Dyskusja

(0)

Zaloguj się aby dołączyć do dyskusji

Ładowanie komentarzy...