Making Deer Antler Buttons — Cross-Section Slices with Sewing Holes
Antler buttons were widely used from the Stone Age through the 19th century before plastic replaced them. Each cross-section slice is unique — the dark cortex ring, lighter spongy centre, and natural colour gradients make every button one of a kind. Deer antler is hard enough to hold up to daily wear and washing, and the material is completely renewable since male deer shed and regrow their antlers every year.
This blueprint covers making a set of two-hole or four-hole sewing buttons from a single deer antler section: sawing thin rounds, sanding flat, drilling sewing holes, and sealing with beeswax.
Instrukcje
Select a beam or thick tine section
Select a beam or thick tine section
Choose a section of the main beam or a thick tine where the diameter matches the button size you want — typically 20-35 mm across. The lower beam produces larger buttons. The natural colour variation in cross-section (dark cortex ring, lighter spongy centre) gives each button a unique appearance.
Materiały do tego kroku:
Deer Antler Section1 sztuka
Deer1 sztukaSaw cross-section slices
Saw cross-section slices
Clamp the antler in a bench vise with protective jaw pads. Cut slices 4-5 mm thick using a fine-toothed hacksaw (32 TPI for the smoothest cut). Saw slowly and let the blade do the work — forcing it produces angled cuts. Mark each cut line with a pencil to keep slices uniform. One 15 cm beam section yields 20-25 buttons.
Tools needed:
Bench Vise
HacksawSand both faces flat
Sand both faces flat
Lay sandpaper (120 grit) flat on a hard surface and sand each button face by rubbing it in small circles. This flattens the hacksaw marks and ensures both faces are parallel. Progress through 220, then 400 grit. The cortex ring becomes glossy and the spongy centre takes on a creamy texture.
Materiały do tego kroku:
Sandpaper (120 Grit)1 arkuszSandpaper (220 Grit)1 arkuszSandpaper (400 Grit)1 arkuszDrill sewing holes
Drill sewing holes
Mark two or four holes evenly spaced, 3-4 mm from the centre. Clamp the slice flat on a scrap board and drill through with a 1.5-2 mm bit at low speed. The slice is thin and can crack if forced, so use light pressure and let the bit cut at its own pace.
Tools needed:
Cordless Drill
Drill Bit SetSeal with beeswax
Seal with beeswax
Rub a thin coat of melted beeswax over each button and buff with a soft cloth. This seals the porous spongy centre and adds a subtle sheen. Buttons sewn onto garments need no re-finishing — body oils keep them conditioned naturally over time.
Materiały do tego kroku:
Beeswax20 gMateriały
6- 1 sztukaPlaceholder
- 1 arkuszPlaceholder
- 1 arkuszPlaceholder
- 1 arkuszPlaceholder
Materiały z połączonych planów
Powiązane blueprinty
Te blueprinty dzielą się wiedzą — technikami, materiałami lub zasadami
CC0 Domena publiczna
Ten plan jest udostępniany na licencji CC0. Możesz go swobodnie kopiować, modyfikować, rozpowszechniać i wykorzystywać do dowolnych celów, bez konieczności uzyskiwania zgody.
Wesprzyj Makera kupując produkty przez jego plan, za co zarabia Prowizja Makera ustalony przez sprzedawców, lub stwórz nową iterację tego planu i dołącz go jako połączenie w swoim własnym planie, aby dzielić się przychodami.