Współpraca
SZTUKA
Piękno i dobre samopoczucie
RZEMIOSŁO
KULTURA I HISTORIA
ROZRYWKA
ŚRODOWISKO
JEDZENIE I NAPOJE
INŻYNIERIA ODWROTNA
NAUKI
LEKKOATLETYKA
TECHNOLOGIA
URZĄDZENIA DO NOSZENIA
Navajo Blanket Weaving: Figure-8 Warp on Two Poles, String Healds, Batten Turned Flat to Open the Shed (Matthews, 1884)
Tex

Autor

Tex

15. listopad 2026FO
5
0
0
0
0

Navajo Blanket Weaving: Figure-8 Warp on Two Poles, String Healds, Batten Turned Flat to Open the Shed (Matthews, 1884)

How a Navajo (Diné) weaver made a blanket, as Washington Matthews recorded it: the warp wound in figures of eight between two poles so both sheds exist from the start, three-strand cords twined across each end, a string heald made loop by loop on a rod, and every pick beaten down with a broad oak batten that is first turned flat to open the shed.
Zaawansowany
Weeks for a blanket

Instrukcje

1

His measures

Wczytywanie notatnika Jupyter…
2

Read Matthews

"It is by the vigorous use of the batten that the Navajo serapes are rendered water-proof."
3

Lay the warp

On the ground make a frame of four sticks: rough saplings at the sides, smooth round poles top and bottom, as far apart as the blanket is long. Tie the warp string to pole 1, take it over pole 2, back under 2 and over 1, and on: the turns cross in the middle in figures of eight, which makes both sheds. Tie off on pole 2 and put a rod in each shed, the rods tied together at their ends.

Materiały do tego kroku:

Przędza wełniana niefarbowanaPrzędza wełniana niefarbowana1 sztuka
Żerdzie z drewna surowegoŻerdzie z drewna surowego1 sztuka

Potrzebne narzędzia:

NóżNóż
4

Twine the end cords

Tie three strings together. Sitting outside one pole, fix them left of the warp; take one strand under the first turn of warp, twist a second strand with the others and take in the second bend, the third the third bend, and so along. Pull the cord tight to space the threads, and do the same at the other pole. These become the stout end edges.

Materiały do tego kroku:

SznurSznur1 sztuka

Potrzebne narzędzia:

NóżNóż
5

Mount and make the healds

Bind the end cords to the loom beams (see the loom blueprint). Keep the upper-shed rod. For the lower shed: pass the end of a ball of string left through the shed, tie a loop on a slender rod, then with a finger draw a fold of string between each pair of front threads, give it one twist into a loop and push the rod through, left to right, until every front thread is in a loop; tie the string to the rod.

Materiały do tego kroku:

SznurSznur1 sztuka

Potrzebne narzędzia:

Prosty warsztat tkacki ramowyProsty warsztat tkacki ramowy
NóżNóż
6

Weave

Sit on the ground facing the loom and weave upward. Lower shed: pull the healds toward you (about 1 in. opening), slide the batten in edgewise and turn it flat to open the shed about 3 in. (8 cm), pass the weft, push it down with the reed-fork, turn the batten edgewise and beat hard. Upper shed: let the healds go, push the shed-rod down to them, and weft, fork and batten again. Pass weft only as far as the batten reaches, rarely over 3 ft (90 cm). Two stout yarn cords, tied at the cloth-beam just outside the warp and up to the yarn-beam, make the side edges.

Materiały do tego kroku:

Barwiona przędza wełnianaBarwiona przędza wełniana1 sztuka

Potrzebne narzędzia:

Prosty warsztat tkacki ramowyProsty warsztat tkacki ramowy
7

Lower the web

When the work gets too high, loosen the spiral rope, lower the yarn-beam, fold the woven part and sew the fold's upper edge tightly to the cloth-beam (needle ours). Most weavers weave a little at the top before finishing the middle, so both ends match.

Materiały do tego kroku:

SznurSznur1 sztuka

Potrzebne narzędzia:

Igła do szyciaIgła do szycia
Prosty warsztat tkacki ramowyProsty warsztat tkacki ramowy
8

Troubleshooting

Weaving troubleshooting.

Flow

Loading...
9

History and honest limits

From Washington Matthews, "Navajo Weavers", **3rd Annual Report of the Bureau of Ethnology** (1884), pp. 378-381, Fig. 43 and Plate XXXV (checked on the archive.org scan 101714660.nlm.nih.gov; p. 380 taken from the scan's text layer). In coarser blankets the end cords were taken out and the warp tied in pairs as a fringe. Yarn amounts, frame size and the needle are ours.

Materiały

4

Wymagane narzędzia

3

Według tego planu powstaje

CC0 Domena publiczna

Ten plan jest udostępniany na licencji CC0. Możesz go swobodnie kopiować, modyfikować, rozpowszechniać i wykorzystywać do dowolnych celów, bez konieczności uzyskiwania zgody.

Wesprzyj Makera kupując produkty przez jego plan, za co zarabia Prowizja Makera ustalony przez sprzedawców, lub stwórz nową iterację tego planu i dołącz go jako połączenie w swoim własnym planie, aby dzielić się przychodami.

Dyskusja

(0)

Zaloguj się aby dołączyć do dyskusji

Ładowanie komentarzy...