Współpraca
SZTUKA
Piękno i dobre samopoczucie
RZEMIOSŁO
KULTURA I HISTORIA
ROZRYWKA
ŚRODOWISKO
JEDZENIE I NAPOJE
INŻYNIERIA ODWROTNA
NAUKI
LEKKOATLETYKA
TECHNOLOGIA
URZĄDZENIA DO NOSZENIA
Protractor: Plain Circular Brass Protractor with a Centre Bar (Stanley, 1878)
Penny

Autor

Penny

3. listopad 2026DK
6
0
0
0
0

Protractor: Plain Circular Brass Protractor with a Centre Bar (Stanley, 1878)

The draughtsman's circular protractor: a flat brass ring divided all round into degrees and half-degrees, its outer edge bevelled thin so a needle point can feel the divisions, with a bar across the middle whose edge runs exactly through the centre from 0° to 180°. Lay the bar on a line, prick off the angle and draw through the point and the centre. Result: a protractor for setting off and measuring angles on a drawing. Source: W. F. Stanley, A Descriptive Treatise on Mathematical Drawing Instruments (1878), pp. 227-228. Unknown: sizes and how the circle is divided. Picture: the book's figure.
Średniozaawansowany
Unknown

Instrukcje

1

Make the ring and bar

Cut a flat ring of brass (electrum also serves) with a bar across the inner space. Make one side of the bar a true straight line through the centre of the ring, and mark the centre with a short line in the middle of the bar; a small semicircle may be cut out of the bar's edge there to make it easier to set over a point. Bevel the outer edge down very thin. Not given: sizes. Ours: brass sheet.

Materiały do tego kroku:

Blacha mosiężnaBlacha mosiężna1 ring and bar

Potrzebne narzędzia:

Nożyce do blachyNożyce do blachy
Tokarka do metaluTokarka do metalu
Nieznane wymiaryNieznane wymiary
2

Divide it

Divide the circumference into degrees, subdivided into half-degrees, so that the bar's edge, carried on, reads 0° and 180°, and number the degrees. Not given: how the circle is divided.

Potrzebne narzędzia:

Nieznane wymiaryNieznane wymiary
3

Use it

To set off an angle from a point on a line, lay the bar so it half covers the line, the line reading 0 to 180, with the point in the centre. Prick off the number of degrees at the bevelled edge with a needle point, lift the protractor away, and draw a line through the mark and the point.

Potrzebne narzędzia:

Nieznane wymiaryNieznane wymiary

Materiały

1

Wymagane narzędzia

3

Według tego planu powstaje

CC0 Domena publiczna

Ten plan jest udostępniany na licencji CC0. Możesz go swobodnie kopiować, modyfikować, rozpowszechniać i wykorzystywać do dowolnych celów, bez konieczności uzyskiwania zgody.

Wesprzyj Makera kupując produkty przez jego plan, za co zarabia Prowizja Makera ustalony przez sprzedawców, lub stwórz nową iterację tego planu i dołącz go jako połączenie w swoim własnym planie, aby dzielić się przychodami.

Dyskusja

(0)

Zaloguj się aby dołączyć do dyskusji

Ładowanie komentarzy...