Współpraca
SZTUKA
Piękno i dobre samopoczucie
RZEMIOSŁO
KULTURA I HISTORIA
ROZRYWKA
ŚRODOWISKO
JEDZENIE I NAPOJE
INŻYNIERIA ODWROTNA
NAUKI
LEKKOATLETYKA
TECHNOLOGIA
URZĄDZENIA DO NOSZENIA
Steel Skelp: Ingot to Bloom to Continuous Skelp Mill (National Tube Co., 1921)
Forge

Autor

Forge

4. listopad 2026NO
8
0
0
1
0

Steel Skelp: Ingot to Bloom to Continuous Skelp Mill (National Tube Co., 1921)

Skelp, the steel strip that welded pipe is made from, as National Tube rolled it in 1921: steel ingots are soaked to an even heat, rolled into blooms and sheared hot to length, then reheated and rolled in a continuous mill into long strips sized for one pipe each. For butt-weld pipe the edges are bevelled slightly and one end is trimmed to a point so the welding tongs can start it through the bell. Unknown: the skelp sizes for each pipe; the 'Spellerizing' roll treatment is named but not described. Source: National Tube Co., "National" Modern Welded Pipe (1921), pp. 38-40. Picture: the continuous skelp mill.
Zaawansowany
Unknown

Instrukcje

1

Soak the ingots

Strip the moulds from the ingots while they are still hot, then set them in a soaking pit and heat them evenly right through to rolling heat. Lift them out with large tongs.

Materiały do tego kroku:

Wlewek stalowyWlewek stalowy1 sztuka

Potrzebne narzędzia:

Piec wgłębnyPiec wgłębny
Kleszcze kowalskieKleszcze kowalskie
2

Roll into blooms

Roll each ingot out longer in the bloom mill, then shear it hot into blooms or slabs of the size the pipe needs.

Potrzebne narzędzia:

WalcarkaWalcarka
3

Roll the skelp

Reheat the blooms and roll them into long strips (skelp). In a continuous mill each bloom passes through several sets of rolls in one direction and comes out as finished skelp. Set the rolls to the length, width and thickness worked out for each size of pipe.

Materiały do tego kroku:

Nieznane wymiaryNieznane wymiary1 sztuka

Potrzebne narzędzia:

WalcarkaWalcarka
4

Finish for butt welding

Bevel the edges slightly, so the strip butts truly when it is drawn through the welding die. Trim one end of each piece roughly to a point and press it to shape, so the welding tongs can start it through the bell.

Potrzebne narzędzia:

WalcarkaWalcarka
Nożyce do blachNożyce do blach

Materiały

2

Wymagane narzędzia

4

Według tego planu powstaje

CC0 Domena publiczna

Ten plan jest udostępniany na licencji CC0. Możesz go swobodnie kopiować, modyfikować, rozpowszechniać i wykorzystywać do dowolnych celów, bez konieczności uzyskiwania zgody.

Wesprzyj Makera kupując produkty przez jego plan, za co zarabia Prowizja Makera ustalony przez sprzedawców, lub stwórz nową iterację tego planu i dołącz go jako połączenie w swoim własnym planie, aby dzielić się przychodami.

Dyskusja

(0)

Zaloguj się aby dołączyć do dyskusji

Ładowanie komentarzy...