Współpraca
SZTUKA
Piękno i dobre samopoczucie
RZEMIOSŁO
KULTURA I HISTORIA
ROZRYWKA
ŚRODOWISKO
JEDZENIE I NAPOJE
INŻYNIERIA ODWROTNA
NAUKI
LEKKOATLETYKA
TECHNOLOGIA
URZĄDZENIA DO NOSZENIA
Uncapping Tray: McIntyre's Uncapping Box (A B C of Bee Culture, 1910)
Woody

Autor

Woody

4. listopad 2026NO
10
0
0
1
0

Uncapping Tray: McIntyre's Uncapping Box (A B C of Bee Culture, 1910)

A big wooden uncapping box from a California honey producer: 6 ft long, tin-lined, with a screen on cross strips to catch the cappings and a tin pipe at one end where the honey drains out, and an iron pivot on a cross piece to spin each comb while uncapping. Its length lets the cappings be forked to the far end to drain for 4 or 5 days instead of piling under the knife. Source: J. F. McIntyre in The A B C and X Y Z of Bee Culture (1910), pp. 183-184. Picture: the book's section and view.
Początkujący
Unknown

Instrukcje

1

Build the box

Make a box 2 ft wide, 2 ft deep and 6 ft long outside of 7/8 in lumber dressed both sides, with the bottom 2 in lower in the middle than at the sides.

Materiały do tego kroku:

DeskaDeska1 7/8 in lumber

Potrzebne narzędzia:

Piła ręcznaPiła ręczna
MłotekMłotek
Gwoździe żelazneGwoździe żelazne
2

Line it and fit the pipe

Line the bottom with tin to keep it from leaking, and fit a tin pipe at one end for the honey to run out.

Materiały do tego kroku:

Arkusz blachy białejArkusz blachy białej1 sztuka

Potrzebne narzędzia:

Nożyce do blachyNożyce do blachy
MłotekMłotek
3

Lay the screen

Lay eleven pieces of wood 1 x 1 x 22 in across the bottom about 6 in apart and lay the screen on them, leaving room below for the honey to run to the pipe end.

Materiały do tego kroku:

DeskaDeska11 1 x 1 x 22 in
Tkanina sitowa z drutuTkanina sitowa z drutu1 sztuka

Potrzebne narzędzia:

Piła ręcznaPiła ręczna
4

Narrow the top and fit the pivot

Nail two pieces 7/8 x 3 x 72 in on the top edges, one each side, to narrow the top to the inside length of a Langstroth hive. Fix one piece 7/8 x 3 x 22 1/4 in across the top about 14 in from one end, with an iron pivot sticking up through it 1 1/2 in high to rest the combs on.

Materiały do tego kroku:

DeskaDeska3 two 7/8 x 3 x 72 in, one 7/8 x 3 x 22 1/4 in
Pręty żelaznePręty żelazne1 pivot 1 1/2 in high
Gwoździe żelazneGwoździe żelazne1 sztuka

Potrzebne narzędzia:

Piła ręcznaPiła ręczna
MłotekMłotek
5

Set it up and use it

Stand the box with its bottom 7 in from the floor so the honey can run into a strainer below; the top is then about 32 in high (make it shallower, or stand on a plank, for a shorter person). Set one end of a comb on the pivot, uncap one side, whirl it round and uncap the other, then stand the comb in the end of the box.

Potrzebne narzędzia:

MłotekMłotek

Materiały

5

Wymagane narzędzia

4

Według tego planu powstaje

CC0 Domena publiczna

Ten plan jest udostępniany na licencji CC0. Możesz go swobodnie kopiować, modyfikować, rozpowszechniać i wykorzystywać do dowolnych celów, bez konieczności uzyskiwania zgody.

Wesprzyj Makera kupując produkty przez jego plan, za co zarabia Prowizja Makera ustalony przez sprzedawców, lub stwórz nową iterację tego planu i dołącz go jako połączenie w swoim własnym planie, aby dzielić się przychodami.

Dyskusja

(0)

Zaloguj się aby dołączyć do dyskusji

Ładowanie komentarzy...