Współpraca
SZTUKA
Piękno i dobre samopoczucie
RZEMIOSŁO
KULTURA I HISTORIA
ROZRYWKA
ŚRODOWISKO
JEDZENIE I NAPOJE
INŻYNIERIA ODWROTNA
NAUKI
LEKKOATLETYKA
TECHNOLOGIA
URZĄDZENIA DO NOSZENIA

Wash Bottle: a Laboratory Wash Bottle with a Slit Valve (Boy Mechanic, 1915)
A wide-mouthed bottle with a three-tube stopper that squirts a steady stream of water for rinsing glassware and washing precipitates. Blow into one tube to pressurise it; a slit rubber valve holds the pressure, and your thumb on a relief tube starts and stops the jet at once.
Source: The Boy Mechanic, Book 2 (1915), p. 458. Unknown: sizes. Picture: the book's sketch.
Początkujący
Unknown
Instrukcje
1
1
Bore the stopper
Bore the stopper
Fit a stopper to a large-mouthed bottle and bore three holes through it for the tubes.
Materiały do tego kroku:
Butelka szklana (bezbarwna)1 large mouth
Korki gumowe1 sztukaPotrzebne narzędzia:
Wiertło do korków2
2
Make the tubes
Make the tubes
Use brass or glass tubes. Bend the nozzle tube E so it reaches the bottom and points out over the side (sketch); the air tube A and relief tube D only pass through the stopper.
Materiały do tego kroku:
Rurka szklana3 sztukPotrzebne narzędzia:
Palnik stołowy do dmuchania szkła3
3
Fit the slit valve
Fit the slit valve
On the lower end of air tube A fit a thick piece of rubber tubing B, stoppered at its bottom end, and cut a slit C in its side: blown air opens it, and it closes again to hold the pressure. Push the three tubes through the stopper and fit it in the bottle. To use: fill with water, blow into A, then close D with your thumb; water jets steadily from E and stops the moment the thumb lifts.
Materiały do tego kroku:
Wąż gumowy1 thick, short piecePotrzebne narzędzia:
Nóż introligatorskiMateriały
4- 1 large mouthZastępnik
- 1 sztukaZastępnik
- 3 sztukZastępnik
- 1 thick, short pieceZastępnik
Wymagane narzędzia
3- Zastępnik
- Zastępnik
- Zastępnik
Według tego planu powstaje
CC0 Domena publiczna
Ten plan jest udostępniany na licencji CC0. Możesz go swobodnie kopiować, modyfikować, rozpowszechniać i wykorzystywać do dowolnych celów, bez konieczności uzyskiwania zgody.
Wesprzyj Makera kupując produkty przez jego plan, za co zarabia Prowizja Makera ustalony przez sprzedawców, lub stwórz nową iterację tego planu i dołącz go jako połączenie w swoim własnym planie, aby dzielić się przychodami.
