فنون
الجمال والعناية
حِرَف
الثقافة والتاريخ
ترفيه
البيئة
الطعام والمشروبات
الهندسة العكسية
العلوم
رياضة
التقنية
الأجهزة القابلة للارتداء
Multi-Conductor Cable: Cotton-Covered, Waxed and Twisted
Penny

أنشأه

Penny

14. أكتوبر 2026DK
13
0
0
0
0

Multi-Conductor Cable: Cotton-Covered, Waxed and Twisted

A cable of several insulated wires in one bundle, such as the four leads of a strain-gauge bridge. Each copper wire is wrapped in cotton thread and soaked in beeswax, then the wires are twisted together and covered again.
مبتدئ
An afternoon

التعليمات

1

Cut the conductors

Cut one copper wire per conductor (four for a bridge), a little longer than the cable.

المواد لهذه الخطوة:

سلك نحاسيسلك نحاسي4 length

الأدوات المطلوبة:

أداة تعرية الأسلاكأداة تعرية الأسلاك
2

Wrap each wire in cotton

Clamp one end in the vise and the other in the hand drill's chuck, keeping it taut. Wind cotton thread on in a close spiral with no gaps, then a second layer the opposite way.

المواد لهذه الخطوة:

خيط قطنيخيط قطني1 as required

الأدوات المطلوبة:

ملزمة منضدةملزمة منضدة
مثقب يدويمثقب يدوي
مقصمقص
3

Soak in beeswax

Melt beeswax in a double boiler and draw each covered wire slowly through it. Wipe off the excess and let it set.

المواد لهذه الخطوة:

شمع النحلشمع النحل1 as required

الأدوات المطلوبة:

قدر الحمّام المائيقدر الحمّام المائي
صفيحة تسخينصفيحة تسخين
4

Twist them together

Lay the covered wires side by side, clamp one end and twist them together evenly with the drill.

الأدوات المطلوبة:

ملزمة منضدةملزمة منضدة
مثقب يدويمثقب يدوي
5

Cover the bundle

Wind an outer layer of cotton over the twisted bundle and wax it again.

المواد لهذه الخطوة:

خيط قطنيخيط قطني1 as required
شمع النحلشمع النحل1 as required

الأدوات المطلوبة:

ملزمة منضدةملزمة منضدة
قدر الحمّام المائيقدر الحمّام المائي
صفيحة تسخينصفيحة تسخين
6

Test it

Strip the ends. With a multimeter check each wire end to end, and check that no two wires touch.

الأدوات المطلوبة:

أداة تعرية الأسلاكأداة تعرية الأسلاك
جهاز قياس متعددجهاز قياس متعدد
7

Limits

Cotton insulation is only good for low temperatures, up to about 105 °C (Wikipedia, Magnet wire), and for dry places and low voltages such as instrument leads. The method is general workshop practice, ours.

المواد

3

الأدوات المطلوبة

7

CC0 ملكية عامة

هذا المخطط مُصدر بموجب CC0. يحق لك نسخه وتعديله وتوزيعه واستخدامه لأي غرض، دون طلب إذن.

ادعم الصانع بشراء منتجات عبر مخططه حيث يكسب عمولة الصانع يحددها البائعون، أو أنشئ نسخة جديدة من هذا المخطط وضمّنه كرابط في مخططك لمشاركة الإيرادات.

النقاش

(0)

تسجيل الدخول للمشاركة في النقاش

جارٍ تحميل التعليقات...