التعاون
فنون
الجمال والعناية
حِرَف
الثقافة والتاريخ
ترفيه
البيئة
الطعام والمشروبات
الهندسة العكسية
العلوم
رياضة
التقنية
الأجهزة القابلة للارتداء
Alcohol Burner: the Glass Spirit Lamp with a Copper Wick Shield (Morfit, 1849)
A small glass lamp that burns alcohol for heating test tubes and small vessels on the bench. Campbell Morfit (1849): the glass body holds the alcohol; a round copper shield with a tube in its centre carries a cotton wick and rests on the neck; a minute hole in the shield lets vapour escape; a glass cap ground to fit the neck keeps the alcohol from evaporating.
Alcohol gives no smoke and does not blacken the glass. Sizes, and how the wick tube is fixed, are not given.
Source: C. Morfit, Chemical and Pharmaceutic Manipulations (1849), pp. 160-162. Picture: Fig. 115.
مبتدئ
Unknown
التعليمات
1
1
Read Morfit
Read Morfit
"To the neck b is adjusted a copper circular shield c, with a tube in its centre for the passage of the wick, which should be of cotton, and similar to that used for tallow candles. The shield should rest upon, rather than within the neck, otherwise its expansion by the heat may cause the breakage of the glass. A minute opening drilled in the shield is also requisite for the escape of vapor in case the alcohol should become heated."
2
2
Make the copper shield
Make the copper shield
Cut a round copper shield a little wider than the neck of the glass body, so it rests on the neck and not inside it. Fix a short copper tube through its centre for the wick (ours: soldered; the joint is not given). Drill a minute hole in the shield for vapour to escape. Sizes are not given (unknown).
المواد لهذه الخطوة:
صفيحة نحاس1 shield
أنبوب نحاسي1 wick tube
لحام قصدير-رصاص1 joint
مساعد صهر1 jointالأدوات المطلوبة:
مقصّ صفائح
كاوية لحام
مثقب يدوي
أبعاد غير معروفة3
3
Fit the wick and the body
Fit the wick and the body
Draw a cotton wick of the tallow-candle kind through the tube so it reaches down into the glass body, which is the alcohol reservoir. Set the shield on the neck. Ours: a clear glass bottle as the body.
المواد لهذه الخطوة:
زجاجة زجاج شفّاف1 body
فتيلة شمعة من قطن1 قطعةالأدوات المطلوبة:
مقصّ صفائح4
4
Fit the glass cap
Fit the glass cap
Cover the wick, when the lamp is not in use, with a glass cap ground inside to fit the neck closely. It stops the alcohol evaporating and the wick taking up water, which makes relighting difficult. Put it on only after the lamp is out. How the cap is made and ground is not given (unknown).
المواد لهذه الخطوة:
زجاج مجهول1 capالأدوات المطلوبة:
أبعاد غير معروفة5
5
Fill and use
Fill and use
Morfit burns alcohol of about specific gravity 0.85. Always put the lamp out before refilling, then pour the spirit in gently until the reservoir is nearly full. The flame is hottest just below its tip; bring the vessel to it gradually, and spread the heat with copper gauze between flame and vessel for larger surfaces.
المواد
7- 1 shieldعنصر نائب
- 1 wick tubeعنصر نائب
- 1 jointعنصر نائب
- 1 jointعنصر نائب
- 1 bodyعنصر نائب
- 1 قطعةعنصر نائب
- 1 capعنصر نائب
هذا المخطط يصنع
CC0 ملكية عامة
هذا المخطط مُصدر بموجب CC0. يحق لك نسخه وتعديله وتوزيعه واستخدامه لأي غرض، دون طلب إذن.
ادعم الصانع بشراء منتجات عبر مخططه حيث يكسب عمولة الصانع يحددها البائعون، أو أنشئ نسخة جديدة من هذا المخطط وضمّنه كرابط في مخططك لمشاركة الإيرادات.