การทำงานร่วมกัน
ศิลปะ
ความงามและสุขภาพ
งานฝีมือ
วัฒนธรรมและประวัติศาสตร์
ความบันเทิง
สิ่งแวดล้อม
อาหารและเครื่องดื่ม
วิศวกรรมย้อนรอย
วิทยาศาสตร์
กีฬา
เทคโนโลยี
อุปกรณ์สวมใส่
Function Generator: Resistance-Capacity Tuned Audio Oscillator with Lamp Amplitude Control (Hewlett, US 2,268,872, 1942)
Ed

สร้างโดย

Ed

3. พฤศจิกายน 2026FI
13
0
0
0
0

Function Generator: Resistance-Capacity Tuned Audio Oscillator with Lamp Amplitude Control (Hewlett, US 2,268,872, 1942)

The first Hewlett-Packard product: a test oscillator tuned by resistors and capacitors instead of coils. Two valve amplifiers feed their output back to their input through a series and a parallel R-C pair, which passes only one frequency in phase, so the circuit oscillates there. A second, negative feedback path through a small lamp holds the amplitude steady: as the swing grows the lamp warms, its resistance rises and the gain falls. One dial covers ten to one in frequency. Result: a sine-wave signal generator covering 20 to 20,000 cycles in three ranges, about 0.25 % distortion. Source: W. R. Hewlett, US 2,268,872 (1942). Unknown: valve types and component values. Picture: the patent drawing.
ขั้นสูง
Unknown

คำแนะนำ

1

Build the two-stage amplifier

Wire two amplifying valves in cascade with resistance-capacity coupling, the first's anode to the second's grid, run as class A amplifiers. Not given: valve types, values, the supplies. Ours: pentode valves in sockets.

วัสดุสำหรับขั้นตอนนี้:

หลอดเพนโทดหลอดเพนโทด2 ชิ้น
ซ็อกเก็ตหลอดซ็อกเก็ตหลอด2 ชิ้น
ความต้านทานความต้านทาน1 ชุด
ชุดตัวเก็บประจุชุดตัวเก็บประจุ1 coupling and by-pass
กล่องอะลูมิเนียมกล่องอะลูมิเนียม1 case
ลวดตะกั่วบัดกรีลวดตะกั่วบัดกรี1 as needed

เครื่องมือที่ต้องใช้:

หัวแร้งบัดกรีหัวแร้งบัดกรี
2

Fit the tuning network

From the second valve's anode, through a coupling capacitor, feed back to the first valve's grid through a resistor R1 in series with a variable capacitor C1, with a resistor R2 and variable capacitor C2 from the grid to ground. Make R1 = R2 and C1 = C2: the frequency is then 1/(2 pi R C), set by the capacitors, giving 10 to 1 on one dial. For the capacitors use a four-gang tuning capacitor with its sections paired in parallel. Switch three sets of resistors in for the ranges 20-200, 200-2000 and 2000-20,000 cycles. Ours: a rotary switch.

วัสดุสำหรับขั้นตอนนี้:

ตัวเก็บประจุปรับค่าได้ (ไดอิเล็กทริกอากาศ)ตัวเก็บประจุปรับค่าได้ (ไดอิเล็กทริกอากาศ)1 four-gang
ความต้านทานความต้านทาน1 three sets of R1, R2
สวิตช์หมุนสวิตช์หมุน1 range switch

เครื่องมือที่ต้องใช้:

หัวแร้งบัดกรีหัวแร้งบัดกรี
ชุดไขควงชุดไขควง
3

Fit the lamp feedback and use it

From the same output, through the coupling capacitor, feed back to the first valve's cathode across a resistor R4 and a small incandescent lamp R3. As the oscillation grows, the lamp heats, its resistance rises, the negative feedback increases and the gain falls, so the amplitude settles below the point of grid current with no clipping. The negative feedback also steadies the gain against valve and supply changes. Take the output from the terminals; Hewlett's test unit held its output within about 10 % over 20-20,000 cycles, with about 0.25 % distortion and under 0.1 % frequency shift with supply changes.

วัสดุสำหรับขั้นตอนนี้:

หลอดไฟหลอดไฟ1 small incandescent lamp
ความต้านทานความต้านทาน1 R4
ขั้วต่อแบบไบดิงโพสต์ขั้วต่อแบบไบดิงโพสต์2 output

เครื่องมือที่ต้องใช้:

แหล่งจ่ายไฟกระแสตรงแหล่งจ่ายไฟกระแสตรง
หัวแร้งบัดกรีหัวแร้งบัดกรี

วัสดุ

10

เครื่องมือที่จำเป็น

3

CC0 สาธารณสมบัติ

พิมพ์เขียวนี้เผยแพร่ภายใต้ CC0 คุณสามารถคัดลอก แก้ไข แจกจ่าย และใช้งานผลงานนี้เพื่อวัตถุประสงค์ใดก็ได้ โดยไม่ต้องขออนุญาต

สนับสนุนเมกเกอร์โดยซื้อสินค้าผ่านพิมพ์เขียวของพวกเขา ซึ่งพวกเขาจะได้รับ ค่าคอมมิชชันเมกเกอร์ ที่ผู้ขายกำหนด หรือสร้างเวอร์ชันใหม่ของพิมพ์เขียวนี้และรวมเป็นการเชื่อมต่อในพิมพ์เขียวของคุณเพื่อแบ่งรายได้

การสนทนา

(0)

เข้าสู่ระบบ เพื่อร่วมการสนทนา

กำลังโหลดความคิดเห็น...