ศิลปะ
ความงามและสุขภาพ
งานฝีมือ
วัฒนธรรมและประวัติศาสตร์
ความบันเทิง
สิ่งแวดล้อม
อาหารและเครื่องดื่ม
อนาคตสีเขียว
วิศวกรรมย้อนรอย
วิทยาศาสตร์
กีฬา
เทคโนโลยี
อุปกรณ์สวมใส่
Making Tallow Candles by Repeated Dipping — The Chandler's Craft
YourGrandma

สร้างโดย

YourGrandma

26. พฤษภาคม 2026IS
3
0
0
0
0

Making Tallow Candles by Repeated Dipping — The Chandler's Craft

Before paraffin wax, most of Europe lit its homes with tallow candles — rendered animal fat (beef or mutton suet) cast or dipped around a cotton or rush wick. The dipping method produces the smoothest, most even candles: a wick is dipped into a tall pot of melted tallow, withdrawn to cool, and dipped again, building up thin layers until the candle reaches the desired thickness. A skilled chandler could dip dozens of candles at once using a dipping frame. This was the everyday light source from the medieval period through the 19th century.

เริ่มต้น
2-3 hours

คำแนะนำ

1

Render the tallow

Cut beef or mutton suet into small cubes (about 2 cm). Place in a heavy pot with a splash of water to prevent scorching. Heat on low for 2-3 hours, stirring occasionally, until all the fat has melted and the crackling solids float. Strain through cheesecloth into a clean pot.

วัสดุสำหรับขั้นตอนนี้:

Beef SuetBeef Suet1 กก.
2

Purify the tallow

Pour the strained tallow into a tall pot of warm water and stir. Allow to cool completely — the tallow solidifies on top, trapping impurities at the water interface. Lift off the tallow disc, scrape the bottom clean, and re-melt. Repeat once more for the cleanest candles.
3

Prepare the wicks

Cut cotton wick to twice the desired candle length plus 5 cm for tying. For a standard taper, use medium-weight braided cotton wick. Straighten the wicks and tie pairs at the centre to a dipping rod — each rod carries 2-6 pairs of wicks hanging down on either side.

วัสดุสำหรับขั้นตอนนี้:

Cotton Candle WickCotton Candle Wick5 เมตร
4

Set up the dipping station

Melt the purified tallow in a tall, narrow pot — deep enough to submerge the full candle length. Maintain the temperature at approximately 65-70°C. Set up a horizontal rod or rack nearby where the dipping rods can rest between dips.
5

Prime the wicks

Dip the bare wicks into the tallow for 3-4 seconds. Withdraw slowly and hang to cool for about 30 seconds. The first coat stiffens the wick and makes it hang straight. This priming coat is essential — without it, the wick curls and produces uneven candles.
6

Begin the dipping cycle

Dip the primed wicks smoothly into the tallow — lower in, pause for 2 seconds, and withdraw in one steady motion. Hang to cool for 1-2 minutes until the surface is no longer tacky. Each dip adds approximately 1 mm of tallow. Repeat.
7

Build up layers

Continue dipping and cooling in rotation. A standard taper candle about 2 cm in diameter requires 20-30 dips. Work multiple rods in rotation — while one set cools, dip the next. Keep the tallow at a consistent temperature; too hot and it melts previous layers, too cool and it sets lumpy.
8

Shape during dipping

After about 15 dips, the candle is thick enough to shape. While still warm from a dip, roll the candle gently on a smooth board to eliminate drips and ensure a perfectly round cross-section. Straighten any curves by rolling with light pressure.
9

Final dips for a smooth finish

For the last 2-3 dips, raise the tallow temperature slightly (to about 75°C). This gives a smoother, glossier surface coat. Withdraw slowly and steadily for the cleanest finish.
10

Cut and flatten the base

While the candle is still slightly warm, cut the bottom flat with a sharp knife so it sits upright in a candlestick. Trim to the desired length. Cut the wick at the top to about 1 cm above the candle surface.
11

Cure the candles

Hang the finished candles in a cool, dry place for 24-48 hours to harden fully. Tallow candles burn best after curing — fresh candles can be soft and drip excessively. Store away from heat and direct sunlight.

วัสดุ

2
  • 1 กก.
    ตัวยึดตำแหน่ง
  • 5 เมตร
    ตัวยึดตำแหน่ง

วัสดุจากพิมพ์เขียวที่เชื่อมต่อ

บลูพริ้นท์ที่เกี่ยวข้อง

บลูพริ้นท์เหล่านี้แบ่งปันความรู้ — เทคนิค วัสดุ หรือหลักการ

CC0 สาธารณสมบัติ

พิมพ์เขียวนี้เผยแพร่ภายใต้ CC0 คุณสามารถคัดลอก แก้ไข แจกจ่าย และใช้งานผลงานนี้เพื่อวัตถุประสงค์ใดก็ได้ โดยไม่ต้องขออนุญาต

สนับสนุนเมกเกอร์โดยซื้อสินค้าผ่านพิมพ์เขียวของพวกเขา ซึ่งพวกเขาจะได้รับ ค่าคอมมิชชันเมกเกอร์ ที่ผู้ขายกำหนด หรือสร้างเวอร์ชันใหม่ของพิมพ์เขียวนี้และรวมเป็นการเชื่อมต่อในพิมพ์เขียวของคุณเพื่อแบ่งรายได้

การสนทนา

(0)

เข้าสู่ระบบ เพื่อร่วมการสนทนา

กำลังโหลดความคิดเห็น...