การทำงานร่วมกัน
ศิลปะ
ความงามและสุขภาพ
งานฝีมือ
วัฒนธรรมและประวัติศาสตร์
ความบันเทิง
สิ่งแวดล้อม
อาหารและเครื่องดื่ม
วิศวกรรมย้อนรอย
วิทยาศาสตร์
กีฬา
เทคโนโลยี
อุปกรณ์สวมใส่
Tangent Galvanometer: 8 Turns on an 11-Inch Wooden Ring with a Pocket Compass (Boy Mechanic, 1913)
Penny

สร้างโดย

Penny

14. พฤศจิกายน 2026DK
5
0
0
0
0

Tangent Galvanometer: 8 Turns on an 11-Inch Wooden Ring with a Pocket Compass (Boy Mechanic, 1913)

A current meter from a wooden ring wound with eight turns of wire and a pocket compass at its centre: set the coil north-south, pass the current, and the needle's swing gives the amperes from a table (0.5 A at 45 degrees).
ระดับกลาง
An afternoon

คำแนะนำ

1

The tangent law

กำลังโหลดสมุด Jupyter…
2

Read the Boy Mechanic

"Any deviation from the dimensions will cause errors in the results obtained by its use."
3

Make the ring

From 1/2 in wood cut a ring 10-1/2 in outside and 9 in inside. Glue on each side a 1/4 in ring, 9 in inside and 11 in outside, to form a 1/4 in channel round the edge (or turn it from solid). Use brass screws and brads only.

วัสดุสำหรับขั้นตอนนี้:

แผ่นไม้เนื้อแข็งแผ่นไม้เนื้อแข็ง1 ชิ้น
กาวไม้กาวไม้1 ชิ้น

เครื่องมือที่ต้องใช้:

เลื่อยฉลุเลื่อยฉลุ
เข็มทิศเข็มทิศ
4

Wind the coil

Wind 8 turns of No. 16 insulated magnet wire in the channel and tie the ends.

วัสดุสำหรับขั้นตอนนี้:

ลวดทองแดงอาบน้ำยาลวดทองแดงอาบน้ำยา1 ชิ้น
เชือกเชือก1 ชิ้น
5

Base

Cut a round base 11 in across with a slot 1 in wide and 6-5/16 in long in the middle. Stand the ring in it with its inner surface level with the top of the base, held by a small strip screwed to the base. Fit two binding posts and connect the coil ends.

วัสดุสำหรับขั้นตอนนี้:

แผ่นไม้เนื้อแข็งแผ่นไม้เนื้อแข็ง1 ชิ้น
ขั้วต่อแบบไบดิงโพสต์ขั้วต่อแบบไบดิงโพสต์1 ชิ้น
สกรูไม้สกรูไม้1 ชิ้น

เครื่องมือที่ต้องใช้:

เลื่อยฉลุเลื่อยฉลุ
สว่านมือหมุนพร้อมดอกสว่านมือหมุนพร้อมดอก
6

Mount the compass

Fix two strips 1/4 x 5/8 x 11 in across the ring with their top edges exactly through its centre, and set a pocket compass about 1-1/4 in across in them, needle centre at the ring centre, zero half-way between the strips. Coat everything with brown shellac.

วัสดุสำหรับขั้นตอนนี้:

แผ่นไม้เนื้อแข็งแผ่นไม้เนื้อแข็ง1 ชิ้น
เข็มทิศแม่เหล็กเข็มทิศแม่เหล็ก1 ชิ้น
น้ำมันเคลือบเชลแล็กน้ำมันเคลือบเชลแล็ก1 ชิ้น

เครื่องมือที่ต้องใช้:

เลื่อยมือเลื่อยมือ
7

Set up and read

Keep iron, steel and magnets away. On a level table turn it until the needle lies in the plane of the coil at zero. Connect the circuit; 45 degrees means 1/2 ampere; use the table for other angles. His table holds near Chicago and east of it north of the Ohio; multiply by 1.3 south of the Ohio and east of the Mississippi.
8

Troubleshooting

Galvanometer troubleshooting.

Flow

Loading...
9

History and honest limits

From **The Boy Mechanic, Book 1** (Popular Mechanics, 1913), pp. 150-151 (checked on the archive.org scan boymechanic0000unse_n5a8). His table equals 0.5 x tan(angle); the field-strength note and modern enamelled wire are ours.

วัสดุ

8

เครื่องมือที่จำเป็น

4

บลูพริ้นท์ที่เกี่ยวข้อง

บลูพริ้นท์เหล่านี้แบ่งปันความรู้ — เทคนิค วัสดุ หรือหลักการ

CC0 สาธารณสมบัติ

พิมพ์เขียวนี้เผยแพร่ภายใต้ CC0 คุณสามารถคัดลอก แก้ไข แจกจ่าย และใช้งานผลงานนี้เพื่อวัตถุประสงค์ใดก็ได้ โดยไม่ต้องขออนุญาต

สนับสนุนเมกเกอร์โดยซื้อสินค้าผ่านพิมพ์เขียวของพวกเขา ซึ่งพวกเขาจะได้รับ ค่าคอมมิชชันเมกเกอร์ ที่ผู้ขายกำหนด หรือสร้างเวอร์ชันใหม่ของพิมพ์เขียวนี้และรวมเป็นการเชื่อมต่อในพิมพ์เขียวของคุณเพื่อแบ่งรายได้

การสนทนา

(0)

เข้าสู่ระบบ เพื่อร่วมการสนทนา

กำลังโหลดความคิดเห็น...