ศิลปะ
ความงามและสุขภาพ
งานฝีมือ
วัฒนธรรมและประวัติศาสตร์
ความบันเทิง
สิ่งแวดล้อม
อาหารและเครื่องดื่ม
วิศวกรรมย้อนรอย
วิทยาศาสตร์
กีฬา
เทคโนโลยี
อุปกรณ์สวมใส่
Teaspoon Sawn Short from Silver Sheet, Then Hammered Out (Payne 1914)
Arthur F. Payne · Public domain (1914)
Forge

สร้างโดย

Forge

27. ตุลาคม 2026NO
14
0
0
0
0

Teaspoon Sawn Short from Silver Sheet, Then Hammered Out (Payne 1914)

Saw the spoon out of flat silver smaller than it will end up: shorter, narrower in the bowl and thicker in the shank. Hammering then stretches it to full size. Arthur Payne said this method was used largely for silver teaspoons. Source: A. F. Payne, Art Metalwork with Inexpensive Equipment (1914), pp. 180–184; annealing from his chapter XI. The millimetre figure is ours. Picture: Payne's Fig. 155, the blank and the finished spoon.
ระดับกลาง
1 day

คำแนะนำ

1

Saw out the short blank

Mark out and saw the blank from 15-gauge sterling silver (about 1.45 mm; our conversion): 5 in long, the bowl 1⅛ in wide and the shank 5⁄16 in wide. The finished spoon will be 6 in long with a bowl 1⅝ in wide.

วัสดุสำหรับขั้นตอนนี้:

เงินสเตอร์ลิงแผ่นบางเงินสเตอร์ลิงแผ่นบาง1 piece 15 gauge, enough for the 5 in blank

เครื่องมือที่ต้องใช้:

เหล็กขีดเหล็กขีด
เลื่อยช่างทองเลื่อยช่างทอง
2

Stretch the bowl wider

Hammer the bowl on a flat anvil with the ball-pein hammer, held at a slight angle towards the side you want it to grow. This makes the bowl thinner and wider.

เครื่องมือที่ต้องใช้:

ทั่งทั่ง
ค้อนหัวกลมค้อนหัวกลม
3

Narrow the shank with the neck hammer

Hold the spoon on edge on a rounded convex stake and hammer the shank narrower with the neck hammer. This lengthens the spoon and makes the shank narrower and thicker. Widen the tip of the handle the same way as the bowl.

เครื่องมือที่ต้องใช้:

หลักหลัก
ค้อนรีดคอค้อนรีดคอ
ค้อนหัวกลมค้อนหัวกลม
4

Anneal and repeat

When the silver gets hard, heat it to a dull red and plunge it into water, or let it cool. Repeat the hammering and annealing until the spoon is roughly to shape.

วัสดุสำหรับขั้นตอนนี้:

น้ำน้ำ1 as required

เครื่องมือที่ต้องใช้:

ตะเกียงบุนเซนตะเกียงบุนเซน
คีมคีบคีมคีบ
ภาชนะแก้วภาชนะแก้ว
5

File and planish

File the rough edges smooth, then planish the whole spoon carefully.

เครื่องมือที่ต้องใช้:

ตะไบ (ตะไบมือ)ตะไบ (ตะไบมือ)
ค้อนเกลาผิวค้อนเกลาผิว
หลักหลัก
6

Polish out the file marks

Rub out all the scratches and file marks with emery cloth.

เครื่องมือที่ต้องใช้:

ผ้าทรายอีเมอรีผ้าทรายอีเมอรี
7

Anneal to even the fire scale

Anneal the spoon thoroughly once more. Heated silver grows a thin white skin, the fire scale, and this brings it back over the spots where filing and polishing took it off, so the colour is even.

วัสดุสำหรับขั้นตอนนี้:

น้ำน้ำ1 as required

เครื่องมือที่ต้องใช้:

ตะเกียงบุนเซนตะเกียงบุนเซน
คีมคีบคีมคีบ
ภาชนะแก้วภาชนะแก้ว
8

Planish with smooth hammers

Planish the spoon on smooth tools with smooth, bright hammers. This makes it stiff again after the annealing.

เครื่องมือที่ต้องใช้:

ค้อนเกลาผิวค้อนเกลาผิว
ทั่งทั่ง
หลักหลัก
9

Final polish with rouge

Polish it lightly with a soft cotton flannel and a little red rouge.

เครื่องมือที่ต้องใช้:

ผ้าขัดเครื่องประดับผ้าขัดเครื่องประดับ
ผงขัดแดงของช่างทองผงขัดแดงของช่างทอง

วัสดุ

2

เครื่องมือที่จำเป็น

14

พิมพ์เขียวนี้สร้าง

บลูพริ้นท์ที่เกี่ยวข้อง

บลูพริ้นท์เหล่านี้แบ่งปันความรู้ — เทคนิค วัสดุ หรือหลักการ

CC0 สาธารณสมบัติ

พิมพ์เขียวนี้เผยแพร่ภายใต้ CC0 คุณสามารถคัดลอก แก้ไข แจกจ่าย และใช้งานผลงานนี้เพื่อวัตถุประสงค์ใดก็ได้ โดยไม่ต้องขออนุญาต

สนับสนุนเมกเกอร์โดยซื้อสินค้าผ่านพิมพ์เขียวของพวกเขา ซึ่งพวกเขาจะได้รับ ค่าคอมมิชชันเมกเกอร์ ที่ผู้ขายกำหนด หรือสร้างเวอร์ชันใหม่ของพิมพ์เขียวนี้และรวมเป็นการเชื่อมต่อในพิมพ์เขียวของคุณเพื่อแบ่งรายได้

การสนทนา

(0)

เข้าสู่ระบบ เพื่อร่วมการสนทนา

กำลังโหลดความคิดเห็น...