İşbirliği
SANAT
GÜZELLİK & SAĞLIK
ZANAAT
KÜLTÜR & TARİH
EĞLENCE
ÇEVRE
YİYECEK & İÇECEK
TERS MÜHENDİSLİK
BİLİMLER
SPOR
TEKNOLOJİ
GİYİLEBİLİR ÜRÜNLER

Cane Glue Brush: the Bark Stripped from One End and the Fibres Hammered Loose (Adamson, Amateur Work, 1887)
The fret-cutter's glue brush recommended by D. B. Adamson in Amateur Work (1887): a piece of cane with the hard outer skin cut away at one end and the end hammered until the fibres loosen into a stiff brush, "better than any other" for rubbing glue into wood.
Başlangıç
A few minutes
Talimatlar
1
1
Read Adamson
Read Adamson
"Nothing is better than a piece of cane beaten out at one end."
2
2
Strip the end
Strip the end
Take a piece of cane (ours: about 15-20 cm) and cut off the hard outer covering for a short distance at one end (ours: about 2 cm).
Bu adım için malzemeler:
Rattan1 adetGerekli aletler:
Maket bıçağı3
3
Beat out the fibres
Beat out the fibres
Lay the stripped end on a hard surface and hammer it until the fibres loosen into a brush.
Gerekli aletler:
Çekiç4
4
Use it
Use it
Warm the glue by standing its can or bottle in a basin of hot water, then rub the glue well into the wood with the brush.
Bu adım için malzemeler:
Su1 adetGerekli aletler:
Kova
Tutkal5
5
Troubleshooting
Troubleshooting
Cane brush troubleshooting.
Flow
Loading...
6
6
History and honest limits
History and honest limits
From D. B. Adamson, "Fretsaw Work and Marquetry Cutting" III, **Amateur Work, Illustrated**, vol. VII (1887), p. 230 (checked on the archive.org scan amateurworkillus71887lond). He gives no lengths: those and the knife are ours.
Bu planla yapılan
CC0 Kamu Malı
Bu plan CC0 lisansıyla yayınlanmıştır. İzin almadan kopyalayabilir, değiştirebilir, dağıtabilir ve herhangi bir amaçla kullanabilirsiniz.
Planı üzerinden ürün satın alarak Maker'ı destekleyin, böylece Maker Komisyonu Satıcılar tarafından belirlenen komisyonu kazanırlar veya bu Planın yeni bir versiyonunu oluşturun ve gelir paylaşımı için kendi Planınıza bağlantı olarak ekleyin.
