İşbirliği
SANAT
GÜZELLİK & SAĞLIK
ZANAAT
KÜLTÜR & TARİH
EĞLENCE
ÇEVRE
YİYECEK & İÇECEK
TERS MÜHENDİSLİK
BİLİMLER
SPOR
TEKNOLOJİ
GİYİLEBİLİR ÜRÜNLER
Trick Lariat That Will Not Twist: Brass Swivels in the Rope and a Choker on the Hondoo (La Rue, 1935)
Tex

Oluşturan

Tex

13. Kasım 2026FO
11
0
0
0
0

Trick Lariat That Will Not Twist: Brass Swivels in the Rope and a Choker on the Hondoo (La Rue, 1935)

Richard L. La Rue of Los Angeles received US 1,993,010, dated 5 March 1935, for a lariat that beginners can spin. A spinning loop twists the rope; an expert lets it roll in the hand, a beginner cannot. La Rue cuts the rope into sections joined by small brass swivels, so the twist runs out. The hondoo, the eye the rope runs through, is clamped in a brass ferrule, and a wire choker can lock the loop at one size. We make it from cotton rope and brass tube. All sizes are ours.
Orta
About 4 hours

Talimatlar

1

Where the swivels go

Jupyter defteri yükleniyor…
2

Read US 1,993,010

"In accordance with the present invention, twisting of the rope is prevented by inserting several swivels at intervals along the rope, so that no matter how the operator holds it there is always at least one swivel between his hand and the loop. The swivels are made substantially the same outside diameter as the rope so that they pass readily through the hondoo."
3

Cut the rope

Cut 6 m of 10 mm braided cotton rope (ours) into the sections the notebook gives. Wrap tape round each place before cutting so the ends do not fray.

Bu adım için malzemeler:

Pamuk halatPamuk halat1 adet

Gerekli aletler:

Şerit MetreŞerit Metre
Maket BıçağıMaket Bıçağı
4

Make the ferrules

For three swivels cut six 25 mm pieces of 3/8 in brass tube (ours), his ferrules 6, and file the ends square. Soften the brass by heating each piece to a dull red with the torch and dropping it in water. On the anvil, tap one end of each inward all round with the hammer, turning it as you go, until the opening is about 4.5 mm: his end wall 7. Flare the other end out a little so the rope will go in.

Bu adım için malzemeler:

Pirinç boru 9,5 mm dış çapPirinç boru 9,5 mm dış çap1 adet

Gerekli aletler:

Demir TesteresiDemir Testeresi
Eğe TakımıEğe Takımı
Propan PürmüzPropan Pürmüz
Su verme kovasıSu verme kovası
SuSu
ÖrsÖrs
Küre başlı çekiçKüre başlı çekiç
Koruyucu gözlükKoruyucu gözlük
5

Join the ferrules into swivels

Cut three 10 mm pieces of 4 mm brass tube (ours), his member 8. Put two ferrules end wall to end wall, push the small tube through both openings, and flare its ends with a centre punch from inside each ferrule until they cannot pull back through: his flanges 9. The two halves must turn freely on each other.

Bu adım için malzemeler:

Pirinç boruPirinç boru1 adet

Gerekli aletler:

Demir TesteresiDemir Testeresi
Nokta ZımbasıNokta Zımbası
Küre başlı çekiçKüre başlı çekiç
Tezgah MengenesiTezgah Mengenesi
6

Fit the rope into the swivels

Push a rope end into each open ferrule as far as it goes. Squeeze the flared end back in, with the hammer on the anvil or in the vice, until it digs into the rope all round. Pull hard on each joint to test it.

Gerekli aletler:

Küre başlı çekiçKüre başlı çekiç
ÖrsÖrs
Tezgah MengenesiTezgah Mengenesi
7

Make the hondoo

Cut 40 mm of brass tube big enough to take the rope doubled (ours) and saw it open along its length. Squeeze one end round the single rope; flatten the other end into an oval. Pass the loop end of the rope through, from the small end, then double its butt end back and push it into the oval end as far as it will go, leaving a small eye: his hondoo 3. Dent the oval end to hold the butt (his 14) and turn one cut edge in against the rope (his 15).

Bu adım için malzemeler:

Pirinç boruPirinç boru1 adet

Gerekli aletler:

Demir TesteresiDemir Testeresi
Tezgah MengenesiTezgah Mengenesi
Yassı Ağızlı PenseYassı Ağızlı Pense
Nokta ZımbasıNokta Zımbası
Küre başlı çekiçKüre başlı çekiç
8

Bend the choker

Bend 2.5 mm steel wire (ours) into a figure 8 round the two rope parts of the hondoo, one eye on each, so it slides when pushed but stays put by friction. Pass the free end of the rope through the hondoo to make the loop.

Bu adım için malzemeler:

Çelik telÇelik tel1 adet

Gerekli aletler:

Yan keskiYan keski
Yuvarlak uçlu penseYuvarlak uçlu pense
Yassı Ağızlı PenseYassı Ağızlı Pense
9

Use it

With the choker pushed up to the ferrule, the rope runs freely through the hondoo like any lariat. To spin a loop of one size, slide the choker away from the ferrule until the hondoo grips the running rope: the loop then stays the same size while it spins.
10

Troubleshooting

Swivel trick lariat troubleshooting.

Flow

Loading...
11

History and honest limits

**Richard L. La Rue** of Los Angeles, US 1,993,010, dated 5 March 1935, filed 16 November 1932, for "a lariat for use by amateurs in performing tricks". He claimed the choker, "a figure 8 clamp of heavy wire", and a clamp "movable back and forth over the doubled rope constituting the hondoo for varying the size of the eye". He also shows a second choker of bent wire (Fig. 6), not built here. He names no rope and gives no sizes: the cotton rope, its length, the tubes, the annealing, the wire and all sizes are ours.

Malzemeler

4

Gerekli Aletler

15

Bu planla yapılan

İlgili Blueprint'ler

Bu blueprint'ler bilgi paylaşır — teknikler, malzemeler veya ilkeler

CC0 Kamu Malı

Bu plan CC0 lisansıyla yayınlanmıştır. İzin almadan kopyalayabilir, değiştirebilir, dağıtabilir ve herhangi bir amaçla kullanabilirsiniz.

Planı üzerinden ürün satın alarak Maker'ı destekleyin, böylece Maker Komisyonu Satıcılar tarafından belirlenen komisyonu kazanırlar veya bu Planın yeni bir versiyonunu oluşturun ve gelir paylaşımı için kendi Planınıza bağlantı olarak ekleyin.

Tartışma

(0)

Giriş yapın tartışmaya katılmak için

Yorumlar yükleniyor...