Співпраця
МИСТЕЦТВО
КРАСА ТА ЗДОРОВ'Я
РЕМЕСЛО
КУЛЬТУРА ТА ІСТОРІЯ
РОЗВАГИ
СЕРЕДОВИЩЕ
ЇЖА ТА НАПІЇ
ЗБОРНА ІНЖЕНЕРІЯ
НАУК
СПОРТ
ТЕХНОЛОГІЯ
НОСИМО
Bismuth: Sweated Out of Native Ore in Inclined Iron Tubes, the Schneeberg Way (Thorpe, 1912)
Charlie

Створено

Charlie

4. листопад 2026DE
13
0
0
0
0

Bismuth: Sweated Out of Native Ore in Inclined Iron Tubes, the Schneeberg Way (Thorpe, 1912)

The old way of getting bismuth from ore that holds it as the metal: heat the lumps just enough in sloping iron tubes and the bismuth, which melts easily, runs out of the rock into pots under charcoal. It takes 30-60 minutes a charge but gets only about two-thirds of the metal. Not given: the furnace temperature. Source: E. Thorpe, Dictionary of Applied Chemistry vol. I (1912), Bismuth, p. 458. Picture: Thorpe's Fig. 1, the furnace in plan.
Середній
30-60 minutes per charge

Інструкції

1

Pick and break the ore

Sort the ore (7-12 % bismuth) by hand from the waste rock as far as possible and break it into pieces the size of a hazel nut.

Матеріали для цього кроку:

Руда самородного вісмутуРуда самородного вісмуту1 12 cwt per tube charge

Необхідні інструменти ({count})

МолотокМолоток
Промислові платформні вагиПромислові платформні ваги
2

Charge the tubes

Load about 12 cwt into each inclined iron tube of the furnace, leaving room to stir from the upper end. Close the upper ends with iron plates and the lower ends with plates pierced with round holes. Under each lower end stand an iron pot holding powdered charcoal, kept gently warm by a small charcoal fire.

Матеріали для цього кроку:

Деревне вугілляДеревне вугілля1 powdered, in the pots and for the pot fire

Необхідні інструменти ({count})

Піч для ліквації вісмутуПіч для ліквації вісмуту
Чавунний тигельЧавунний тигель
3

Sweat out the bismuth

Fire the furnace with wood so that the metal flows easily. In about 10 minutes the bismuth begins to run into the pots, where the charcoal covers it from the air. Stir the ore now and then with an iron rod from the upper end; in 30-60 minutes the charge is done. 20 cwt of ore burns about 63 cubic feet of wood.

Матеріали для цього кроку:

ДроваДрова1 about 63 cu ft per 20 cwt of ore

Необхідні інструменти ({count})

Піч для ліквації вісмутуПіч для ліквації вісмуту
Круглий залізний прутокКруглий залізний пруток
4

Rake out and recharge

Rake the spent ore (bismuth barley) out of the upper end into the tank and refill at once with fresh ore.

Необхідні інструменти ({count})

Залізні грабліЗалізні граблі
Піч для ліквації вісмутуПіч для ліквації вісмуту
5

Cast ingots

Ladle the bismuth from the pots into moulds and cast ingots of 25-50 lb.

Необхідні інструменти ({count})

Чавунний тигельЧавунний тигель
Ливарний ківшЛиварний ківш
ВиливницяВиливниця

Матеріали

3

Необхідні інструменти

8

За цим кресленням виготовляють

CC0 Суспільне надбання

Це креслення випущено під ліцензією CC0. Ви можете вільно копіювати, змінювати, поширювати та використовувати цю роботу для будь-яких цілей без запиту дозволу.

Підтримайте мейкера, купуючи продукти через його креслення, де він отримує Комісію мейкера встановлену вендорами, або створіть нову ітерацію цього креслення та включіть його як зв'язок у власне креслення для розподілу доходу.

Обговорення

(0)

Увійти щоб приєднатися до обговорення

Завантаження коментарів...