Співпраця
МИСТЕЦТВО
КРАСА ТА ЗДОРОВ'Я
РЕМЕСЛО
КУЛЬТУРА ТА ІСТОРІЯ
РОЗВАГИ
СЕРЕДОВИЩЕ
ЇЖА ТА НАПІЇ
ЗБОРНА ІНЖЕНЕРІЯ
НАУК
СПОРТ
ТЕХНОЛОГІЯ
НОСИМО
Coil Spring: Small Springs Wound Through a Nut (Boy Mechanic, 1915)
Forge

Створено

Forge

4. листопад 2026NO
17
0
0
0
0

Coil Spring: Small Springs Wound Through a Nut (Boy Mechanic, 1915)

Small, even coil springs wound by hand: spring wire is turned round a rod that runs through a nut held in a vise, and the nut's thread lays every coil at the same pitch. Variable: the nut's thread pitch gives open or closed coils. Source: The Boy Mechanic, Book 2 (1915), p. 197. Picture: the book's sketch.
Початківець
Unknown

Інструкції

1

Prepare the nut and rod

Take a nut whose thread will take the spring wire, and file a small notch, as deep as the thread, where the thread starts. Take a smooth rod that passes snugly through the nut. Shape one end to fit a brace (or a drill chuck) and drill a hole across the other end for the wire.

Необхідні інструменти ({count})

Шестигранна гайкаШестигранна гайка
Круглий пруток із маловуглецевої сталіКруглий пруток із маловуглецевої сталі
Напилок по металуНапилок по металу
Ручний дрильРучний дриль
2

Wind the spring

Bend the end of the wire at right angles and push it into the hole. Grip the nut in a vise, put the rod through it, and turn the rod with the brace, guiding the wire into the notch at the start of the thread. The wire follows the thread and comes out as an even spring. Cut it to length.

Матеріали для цього кроку:

Пружинний сталевий дрітПружинний сталевий дріт1 штука

Необхідні інструменти ({count})

Слюсарні лещатаСлюсарні лещата
Коловорот із перкоюКоловорот із перкою
Ножиці по металуНожиці по металу

Матеріали

1

Необхідні інструменти

7

За цим кресленням виготовляють

CC0 Суспільне надбання

Це креслення випущено під ліцензією CC0. Ви можете вільно копіювати, змінювати, поширювати та використовувати цю роботу для будь-яких цілей без запиту дозволу.

Підтримайте мейкера, купуючи продукти через його креслення, де він отримує Комісію мейкера встановлену вендорами, або створіть нову ітерацію цього креслення та включіть його як зв'язок у власне креслення для розподілу доходу.

Обговорення

(0)

Увійти щоб приєднатися до обговорення

Завантаження коментарів...