МИСТЕЦТВО
КРАСА ТА ЗДОРОВ'Я
РЕМЕСЛО
КУЛЬТУРА ТА ІСТОРІЯ
РОЗВАГИ
СЕРЕДОВИЩЕ
ЇЖА ТА НАПІЇ
ЗБОРНА ІНЖЕНЕРІЯ
НАУК
СПОРТ
ТЕХНОЛОГІЯ
НОСИМО

Getting the Solid Back: Evaporate, Crystallise, and Dry to Constant Mass
Boiling a solution dry gives you everything that was dissolved in it, including the impurities. Letting it crystallise slowly gives you the substance you wanted and leaves most of the impurities in the liquid — because a growing crystal is fussy about what it lets in.
So evaporating to dryness and crystallising are not two ways of doing the same job. The first is for recovering everything; the second is for purifying.
Then there is the question of when it is actually DRY, which cannot be answered by looking. The answer is a measurement loop: dry, weigh, dry again, weigh again, and stop when the mass stops changing.
Середній
3 hours
Інструкції
1
1
Evaporate gently, and never to the last drop over heat
Evaporate gently, and never to the last drop over heat
Use a wide, shallow evaporating dish rather than a beaker: evaporation happens at the surface, so the area is what sets the speed, and a wide dish is faster at a much lower temperature.
Stop while a little liquid remains and let the rest go at room temperature. Once the liquid is nearly gone there is nothing left to absorb the heat, the solid overheats in seconds, and it spits, decomposes or bakes onto the dish.
A steam bath or a hot plate on a low setting is better than a flame for anything that matters. Direct flame heats one spot far above the boiling point of the solution, and many substances that survive 100 degrees do not survive that.
Матеріали для цього кроку:
Дистильована вода1 літр
Хлорид натрію (сіль)1 штукаНеобхідні інструменти ({count})
Випарювальна чашка
Електроплитка
Годинникове скло2
2
Crystallise slowly, and crystallise on purpose
Crystallise slowly, and crystallise on purpose
Dissolve the solid in the smallest volume of hot solvent that will take it, then let it cool UNDISTURBED. Slow cooling grows few, large, pure crystals; rapid cooling or stirring gives a mass of tiny ones that trap the mother liquor and everything dissolved in it.
If nothing appears, it is usually because there is too much solvent or because there is no nucleus to start on. Boil a little solvent off, scratch the inside of the glass with a rod at the surface, or add one seed crystal.
Then filter the crystals off cold and rinse them with a SMALL amount of ICE-COLD solvent. Rinsing with warm solvent dissolves the product you just spent an hour growing, which is the most disheartening way to lose a yield.
Матеріали для цього кроку:
Дистильована вода1 літр
Сульфат міді п'ятиводний (CuSO4·5H2O)1 штукаНеобхідні інструменти ({count})
Скляна хімічна склянка
Скляна паличка для перемішування
Лійка Бюхнера (порцелянова)
Фільтрувальний папір3
3
Dry to constant mass, which is a measurement not a judgement
Dry to constant mass, which is a measurement not a judgement
Завантаження блокнота Jupyter…
Матеріали для цього кроку:
Хлорид натрію (сіль)1 штукаНеобхідні інструменти ({count})
Сушильна піч
Скляний ексикатор
Прецизійні ваги
Настільний комп'ютер4
4
Work out the yield, and be honest about it
Work out the yield, and be honest about it
Percentage yield is what you got divided by what the equation says you could have got. Both numbers have to be real: the mass actually recovered and dried, and the theoretical mass calculated from the LIMITING reagent.
Yields above 100% mean the product is not dry, or it has picked up something. That is worth treating as a fault rather than a bonus, because a wet product weighs more and is worth less.
Record where the losses went, in the notebook: left in the mother liquor, stuck to the filter paper, lost in the rinse, spilled. Those lines are what make the next attempt better, and a yield with no explanation attached is a number nobody can improve.
Необхідні інструменти ({count})
Прецизійні ваги
КалькуляторМатеріали
3- 2 літрівЗаповнювач
- 1 штукаЗаповнювач
- Заповнювач
Необхідні інструменти
12- Заповнювач
- Заповнювач
- Заповнювач
- Заповнювач
- Заповнювач
- Заповнювач
- Заповнювач
- Заповнювач
- Скляний ексикатор10% комісіяЗаповнювач
- Заповнювач
- Заповнювач
- Заповнювач
Пов'язані креслення
Ці креслення діляться знаннями — техніки, матеріали або принципи
CC0 Суспільне надбання
Це креслення випущено під ліцензією CC0. Ви можете вільно копіювати, змінювати, поширювати та використовувати цю роботу для будь-яких цілей без запиту дозволу.
Підтримайте мейкера, купуючи продукти через його креслення, де він отримує Комісію мейкера встановлену вендорами, або створіть нову ітерацію цього креслення та включіть його як зв'язок у власне креслення для розподілу доходу.


