Співпраця
МИСТЕЦТВО
КРАСА ТА ЗДОРОВ'Я
РЕМЕСЛО
КУЛЬТУРА ТА ІСТОРІЯ
РОЗВАГИ
СЕРЕДОВИЩЕ
ЇЖА ТА НАПІЇ
ЗБОРНА ІНЖЕНЕРІЯ
НАУК
СПОРТ
ТЕХНОЛОГІЯ
НОСИМО

Lead Came Mould: Two Hinged Grooved Irons (Theophilus, tr. Hendrie 1847)
The iron mould in which Theophilus cast the lead rods of glass windows: two irons a yard long, hinged at one end with a nail, filed to close without a chink of light, with a matching groove hollowed down the middle of each so the lead poured in makes one rod.
The free ends are made a little wider and thinner to form a pouring mouth, and the two halves are keyed so they cannot slip while casting.
Source: Theophilus, De Diversis Artibus, Book II, ch. XXIV, tr. R. Hendrie (1847), p. 147. Picture: the chapter.
Середній
Unknown
Інструкції
1
1
Hinge the irons
Hinge the irons
Take two irons two fingers broad, one finger thick and a yard long. Join them at one end like a hinge, fastened by a nail, so they open and shut. Make the other ends a little wider and thinner, so that when shut they form the start of a cavity (the pouring mouth). Not given: how the hinge is formed.
Матеріали для цього кроку:
Прутки кованого заліза2 2 fingers x 1 finger x 1 yard
Цвяхи1 hinge pinНеобхідні інструменти ({count})
Молоток2
2
Fit the faces
Fit the faces
Let the outer sides lie even, and file the two faces together until no light shows between them when closed.
Необхідні інструменти ({count})
Напилок по металу3
3
Cut the grooves
Cut the grooves
Open the irons. With a rule, draw two narrow lines down the middle of each piece, facing each other, from top to bottom. Hollow out between them with the chasing iron used for hollowing lamps, as deep as you wish, and rasp a little inside so the lead poured in makes one piece. Key the mouth so one half cannot slip on the other while casting.
Необхідні інструменти ({count})
Лінійка
РашпільМатеріали
2- 2 2 fingers x 1 finger x 1 yardЗаповнювач
- 1 hinge pinЗаповнювач
За цим кресленням виготовляють
CC0 Суспільне надбання
Це креслення випущено під ліцензією CC0. Ви можете вільно копіювати, змінювати, поширювати та використовувати цю роботу для будь-яких цілей без запиту дозволу.
Підтримайте мейкера, купуючи продукти через його креслення, де він отримує Комісію мейкера встановлену вендорами, або створіть нову ітерацію цього креслення та включіть його як зв'язок у власне креслення для розподілу доходу.
