Співпраця
МИСТЕЦТВО
КРАСА ТА ЗДОРОВ'Я
РЕМЕСЛО
КУЛЬТУРА ТА ІСТОРІЯ
РОЗВАГИ
СЕРЕДОВИЩЕ
ЇЖА ТА НАПІЇ
ЗБОРНА ІНЖЕНЕРІЯ
НАУК
СПОРТ
ТЕХНОЛОГІЯ
НОСИМО

Plate Shears: Bench Shears Made from a Flat File (Shop Notes, 1919)
Bench shears for sheet metal too heavy for hand snips: a 14 in flat file, ground and sharpened, works as a lever knife bolted against a fixed cutter forged from scrap steel and fastened to the bench.
Source: Popular Mechanics Shop Notes for 1919, p. 3271. Unknown: cutter and bolt sizes. Picture: the book's photo and drawing.
Середній
Unknown
Інструкції
1
1
Make the moving knife
Make the moving knife
Take a 14 in flat file. Grind one side smooth and sharpen part of the tip and one edge. Heat it cherry red and punch the bolt hole.
Матеріали для цього кроку:
Напилок по металу1 14 in flat fileНеобхідні інструменти ({count})
Настільний точильний станок
Горно
Щипці
Гарячий пробійник
Молоток2
2
Forge the fixed cutter
Forge the fixed cutter
Forge the fixed cutter from part of an old plowshare or other suitable scrap steel, bent as in the drawing so it can be screwed to the bench, with a hole for the pivot bolt.
Матеріали для цього кроку:
Пруток вуглецевої сталі (0,6 % C)1 scrap steelНеобхідні інструменти ({count})
Горно
Щипці
Молоток
Гарячий пробійник3
3
Assemble on the bench
Assemble on the bench
Screw the fixed cutter to the bench and bolt the file knife to it. Use a locknut on the bolt, or rivet the end over.
Матеріали для цього кроку:
Болт із шестигранною головкою - клас 8.81 штука
Шестигранна гайка2 nut and locknut
Шурупи по дереву1 штукаНеобхідні інструменти ({count})
Розвідний ключ
Викрутка пласкаМатеріали
5- 1 14 in flat fileЗаповнювач
- 1 scrap steelЗаповнювач
- Заповнювач
- 2 nut and locknutЗаповнювач
- 1 штукаЗаповнювач
За цим кресленням виготовляють
CC0 Суспільне надбання
Це креслення випущено під ліцензією CC0. Ви можете вільно копіювати, змінювати, поширювати та використовувати цю роботу для будь-яких цілей без запиту дозволу.
Підтримайте мейкера, купуючи продукти через його креслення, де він отримує Комісію мейкера встановлену вендорами, або створіть нову ітерацію цього креслення та включіть його як зв'язок у власне креслення для розподілу доходу.
