Співпраця
МИСТЕЦТВО
КРАСА ТА ЗДОРОВ'Я
РЕМЕСЛО
КУЛЬТУРА ТА ІСТОРІЯ
РОЗВАГИ
СЕРЕДОВИЩЕ
ЇЖА ТА НАПІЇ
ЗБОРНА ІНЖЕНЕРІЯ
НАУК
СПОРТ
ТЕХНОЛОГІЯ
НОСИМО
Rubber Compound: Raw Rubber Washed, Dried and Mixed with Sulphur on Hot Rolls (Thorpe, 1913)
Charlie

Створено

Charlie

4. листопад 2026DE
11
0
0
0
0

Rubber Compound: Raw Rubber Washed, Dried and Mixed with Sulphur on Hot Rolls (Thorpe, 1913)

How a rubber works of 1913 turned raw rubber into a 'mixing' ready for shaping and curing: the rubber is washed between corrugated rolls under running water, dried on racks, broken down on hot smooth rolls until plastic, and then worked together with fillers and finally sulphur into an even dough. Very few goods were made of rubber and sulphur alone: pure mixings cost too much and are too soft for most uses. Unknown: which fillers, and how much of them and of sulphur. Thorpe names the kinds of materials but gives no mixing. Source: T. E. Thorpe, Dictionary of Applied Chemistry vol. IV (1913), pp. 586-587. Picture: Fig. 1, a washing machine.
Середній
3-4 days drying

Інструкції

1

Steep and wash the rubber

Cut the raw rubber into lumps or slabs and steep them for some hours in warm water. Pass them again and again through corrugated, diamond-cut or fluted rolls running at a speed difference of 6 : 4 down to one tooth, with a stream of water on the rubber, until the rough crepe-like sheet is clean and thin.

Матеріали для цього кроку:

Копчений лист каучукуКопчений лист каучуку1 raw rubber
ВодаВода1 warm, then running

Необхідні інструменти ({count})

Двовалкові вальці для гумиДвовалкові вальці для гуми
2

Dry on racks

Hang the sheet on racks in a drying room until it holds only about 0.25-0.5 per cent moisture: about 3-4 days at about 80°F with good ventilation. Cooler, drier air is better, as warm rubber turns soft and tacky.

Необхідні інструменти ({count})

Сушильний стелажСушильний стелаж
3

Break it down

Pass the dry rubber repeatedly through the steam-heated smooth rolls of the mixing machine, which run at different speeds, tightening the rolls gradually until the rubber is thoroughly plastic.

Необхідні інструменти ({count})

Двовалкові вальці для гумиДвовалкові вальці для гуми
4

Mix in the fillers and sulphur

Add the other materials gradually: reclaimed rubber, ground waste, 'substitute' and other organic fillers first, then the minerals and the sulphur last. Work it into a thoroughly even dough without overworking ('tiring') the rubber.

Матеріали для цього кроку:

Невідомий матеріалНевідомий матеріал1 fillers and minerals; not given
Порошкова сіркаПорошкова сірка1 amount not given

Необхідні інструменти ({count})

Двовалкові вальці для гумиДвовалкові вальці для гуми

Матеріали

4

Необхідні інструменти

2

За цим кресленням виготовляють

CC0 Суспільне надбання

Це креслення випущено під ліцензією CC0. Ви можете вільно копіювати, змінювати, поширювати та використовувати цю роботу для будь-яких цілей без запиту дозволу.

Підтримайте мейкера, купуючи продукти через його креслення, де він отримує Комісію мейкера встановлену вендорами, або створіть нову ітерацію цього креслення та включіть його як зв'язок у власне креслення для розподілу доходу.

Обговорення

(0)

Увійти щоб приєднатися до обговорення

Завантаження коментарів...