Співпраця
МИСТЕЦТВО
КРАСА ТА ЗДОРОВ'Я
РЕМЕСЛО
КУЛЬТУРА ТА ІСТОРІЯ
РОЗВАГИ
СЕРЕДОВИЩЕ
ЇЖА ТА НАПІЇ
ЗБОРНА ІНЖЕНЕРІЯ
НАУК
СПОРТ
ТЕХНОЛОГІЯ
НОСИМО
Wash Bottle: a Laboratory Wash Bottle with a Slit Valve (Boy Mechanic, 1915)
Charlie

Створено

Charlie

4. листопад 2026DE
15
0
0
0
0

Wash Bottle: a Laboratory Wash Bottle with a Slit Valve (Boy Mechanic, 1915)

A wide-mouthed bottle with a three-tube stopper that squirts a steady stream of water for rinsing glassware and washing precipitates. Blow into one tube to pressurise it; a slit rubber valve holds the pressure, and your thumb on a relief tube starts and stops the jet at once. Source: The Boy Mechanic, Book 2 (1915), p. 458. Unknown: sizes. Picture: the book's sketch.
Початківець
Unknown

Інструкції

1

Bore the stopper

Fit a stopper to a large-mouthed bottle and bore three holes through it for the tubes.

Матеріали для цього кроку:

Скляна бутля (прозора)Скляна бутля (прозора)1 large mouth
Гумові коркиГумові корки1 штука

Необхідні інструменти ({count})

Свердло для корківСвердло для корків
2

Make the tubes

Use brass or glass tubes. Bend the nozzle tube E so it reaches the bottom and points out over the side (sketch); the air tube A and relief tube D only pass through the stopper.

Матеріали для цього кроку:

Скляна трубкаСкляна трубка3 штук

Необхідні інструменти ({count})

Настільний пальник склодуваНастільний пальник склодува
3

Fit the slit valve

On the lower end of air tube A fit a thick piece of rubber tubing B, stoppered at its bottom end, and cut a slit C in its side: blown air opens it, and it closes again to hold the pressure. Push the three tubes through the stopper and fit it in the bottle. To use: fill with water, blow into A, then close D with your thumb; water jets steadily from E and stops the moment the thumb lifts.

Матеріали для цього кроку:

Гумова трубкаГумова трубка1 thick, short piece

Необхідні інструменти ({count})

Макетний ніжМакетний ніж

Матеріали

4

Необхідні інструменти

3

За цим кресленням виготовляють

CC0 Суспільне надбання

Це креслення випущено під ліцензією CC0. Ви можете вільно копіювати, змінювати, поширювати та використовувати цю роботу для будь-яких цілей без запиту дозволу.

Підтримайте мейкера, купуючи продукти через його креслення, де він отримує Комісію мейкера встановлену вендорами, або створіть нову ітерацію цього креслення та включіть його як зв'язок у власне креслення для розподілу доходу.

Обговорення

(0)

Увійти щоб приєднатися до обговорення

Завантаження коментарів...