Collaboration
ART
BEAUTY & WELLNESS
CRAFT
CULTURE & HISTORY
ENTERTAINMENT
ENVIRONMENT
FOOD & DRINKS
REVERSE ENGINEERING
SCIENCES
SPORTS
TECHNOLOGY
WEARABLES

Leather Punch from an Old Pipe Nipple: Edge Ground Thin, Slug Slot Cut Above (Boy Mechanic, 1915)
A shop-made hollow punch for round holes in leather from The Boy Mechanic, Book 2 (1915): an old pipe nipple of the size you need, one end ground on the outside to a very thin cutting edge, and a small slot a little above it to push the leather slugs out.
Beginner
Half an hour
Instructions
1
1
Read the tip
Read the tip
"The cutter end can be ground very thin to prevent an over-cut, while a small slot cut a little above it will allow the removal of the leather slugs."
2
2
Choose the pipe
Choose the pipe
Pick an old pipe nipple whose bore matches the hole you want: pieces of almost any size turn up around a shop. If the piece is long, saw it to a handy length (ours).
Materials for this step:
Steel Pipe (thick-walled, threaded ends)1 pieceTools needed:
Bench Vise
Hacksaw3
3
Grind the cutter end
Grind the cutter end
Grind one end on the outside to a long bevel, leaving a very thin edge round the bore, as the hatched section in the sketch shows. Keep turning the pipe so the edge stays even.
Tools needed:
Bench Grinder4
4
Cut the slug slot
Cut the slug slot
A little above the edge, cut a small slot through the wall (the sketch shows a triangle) to push the slugs out. Ours: drill a hole and file it to shape.
Tools needed:
Bench Vise
Drill Press
Files (Hand File)
Needle Files5
5
Punch
Punch
Ours: lay the leather on end-grain wood, stand the punch upright and strike the top with a mallet. Poke the slugs out through the slot.
Tools needed:
Wooden Mallet6
6
Troubleshooting
Troubleshooting
Punch troubleshooting.
Flow
Loading...
7
7
History and honest limits
History and honest limits
From "Pipe Used as a Leather Punch", **The Boy Mechanic, Book 2** (Popular Mechanics, 1915), p. 138 (checked on the archive.org scan boymechanicbook200chic2). The note gives no sizes; the way the slot is cut, the length and the striking method are ours.
Materials
1- Placeholder
Tools Required
7- Placeholder
- Placeholder
- Placeholder
- Placeholder
- Placeholder
- Placeholder
- Placeholder
This blueprint makes
Related Blueprints
These blueprints share knowledge with this one โ techniques, materials, or principles that connect them in the learning graph.
CC0 Public Domain
This blueprint is released under CC0. You are free to copy, modify, distribute, and use this work for any purpose, without asking permission.
Support the Maker by purchasing products through their Blueprint where they earn a Maker Commission set by Vendors, or create a new iteration of this Blueprint and include it as a connection in your own Blueprint to share revenue.


