NGHỆ THUẬT
LÀM ĐẸP VÀ SỨC KHỎE
THỦ CÔNG
VĂN HÓA VÀ LỊCH SỬ
GIẢI TRÍ
MÔI TRƯỜNG
THỰC PHẨM VÀ ĐỒ UỐNG
KỸ THUẬT NGƯỢC
KHOA HỌC
THỂ THAO
CÔNG NGHỆ
THIẾT BỊ ĐEO
Pneumatic Tube Post
Ed

Tạo bởi

Ed

20. tháng Tám 2026FI
1
0
0
0
0

Pneumatic Tube Post

Before the telephone, the fastest way to move a message across a city was to put it in a cylinder and blow it through a pipe. A carrier sealed by felt or leather rings fits the bore closely; make a pressure difference across it — pump air in behind or suck it out ahead — and the carrier is driven along at twenty or thirty miles an hour, around corners, under streets, from one building to another. London's first line opened in 1853 between the Stock Exchange and a telegraph office; Paris built a network of hundreds of kilometres that carried the petit bleu until 1984. It is an unglamorous piece of engineering that solved a real problem: a telegram still had to be physically carried from the telegraph office to the recipient, and the tube did that leg faster than any messenger could.
Cơ bản
45 minutes

Hướng dẫn

1

Build the tube and a carrier

The fit between carrier and bore is the whole engineering problem.

  1. Take a straight length of smooth tube.
  2. Make a carrier slightly smaller than the bore.
  3. Fit felt or foam rings at each end so it seals but still slides.
Too tight and friction stops it; too loose and air simply blows past. Real systems used replaceable felt rings for exactly this reason — the seal is a wearing part, and it is the part that decides whether the system works.

Vật liệu cho bước này:

PVC Pipe (50 mm)PVC Pipe (50 mm)1 length
Cork SheetCork Sheet1 tờ
2

Push, then pull

Two ways to make the pressure difference, and they are not equivalent.

  1. Blow into one end with a vacuum cleaner on its blower port and watch the carrier travel.
  2. Now apply suction at the far end instead.
  3. Compare the speed and the smoothness.
Vacuum can only ever produce one atmosphere of difference — about 100 kPa, and in practice much less. Pressure has no such ceiling. Long systems therefore pushed; short ones often sucked, because a suction system leaks inward and stays clean rather than blowing dust out at every joint.

Vật liệu cho bước này:

Vacuum Pump - 12VVacuum Pump - 12V1 cái
3

Measure speed against pressure

Turn it into a measurement.

  1. Mark a measured run length on the tube.
  2. Time the carrier over that distance at several blower settings.
  3. Plot speed against setting.
Speed rises with pressure difference but not proportionally — drag rises steeply with speed, and a longer tube has more wall friction. This is why a network needs booster stations rather than one enormous pump at the middle.

Vật liệu cho bước này:

StopwatchStopwatch1 cái
Steel RulerSteel Ruler1 cái
4

Solve the arrival problem

A carrier arriving at 30 km/h has to be stopped without being destroyed.

  1. Send a carrier hard into a bare tube end and inspect the damage.
  2. Add a cushion of trapped air by restricting — not blocking — the exit.
  3. Repeat and compare.
A partly restricted outlet compresses the air ahead of the carrier into a spring that decelerates it. Real terminals used exactly this, plus padded catchers. Blocking the outlet entirely stops the airflow and the carrier stalls short of the station — a nice illustration that the working fluid has to keep moving for the system to work at all.
5

History and context

London, 1853: the first commercial pneumatic despatch line ran a short distance between the Stock Exchange and the Electric Telegraph Company. The idea grew fast because it solved the last-leg problem of telegraphy — a telegram crossed the country in minutes and then waited for a boy with a bicycle.

Paris built the largest network in the world. The poste pneumatique eventually ran to hundreds of kilometres under the city, and a petit bleu — a message on blue paper — could cross Paris in well under an hour. It ran until 1984, outliving the telegram itself.

The scaled-up versions failed. London's Pneumatic Despatch Company built tubes large enough for parcel wagons in the 1860s, and Alfred Ely Beach demonstrated a pneumatic passenger subway under Broadway in 1870. Neither worked economically; sealing a large bore against leakage is very much harder than sealing a small one, and the power required scales badly. Small tubes for documents were the viable size, and remain so.

Still in daily use. Hospitals move blood samples and drugs through pneumatic tubes because a physical sample cannot be emailed, banks use them at drive-through windows, and large factories and supermarkets move cash. A technology that lost to the telephone for messages still wins for objects — and the modern hyperloop proposals are the same push-a-sealed-carrier-through-a-tube idea at a scale that has failed twice before.

Vật liệu

5
Tổng ước tính
$14.00

CC0 Phạm vi công cộng

Bản thiết kế này được phát hành theo CC0. Bạn tự do sao chép, sửa đổi, phân phối và sử dụng cho bất kỳ mục đích nào mà không cần xin phép.

Hỗ trợ nhà sáng tạo bằng cách mua sản phẩm qua bản thiết kế, nơi họ nhận Hoa hồng nhà sáng tạo do nhà bán hàng đặt, hoặc tạo phiên bản mới và kết nối trong bản thiết kế riêng để chia sẻ doanh thu.

Thảo luận

(0)

Đăng nhập để tham gia thảo luận

Đang tải bình luận...