NGHỆ THUẬT
LÀM ĐẸP VÀ SỨC KHỎE
THỦ CÔNG
VĂN HÓA VÀ LỊCH SỬ
GIẢI TRÍ
MÔI TRƯỜNG
THỰC PHẨM VÀ ĐỒ UỐNG
KỸ THUẬT NGƯỢC
KHOA HỌC
THỂ THAO
CÔNG NGHỆ
THIẾT BỊ ĐEO
SODIS: Disinfecting Water with Sunlight
Bob

Tạo bởi

Bob

23. tháng Chín 2026BE
18
0
0
0
0

SODIS: Disinfecting Water with Sunlight

Every rung so far needed something: alum, a kiln, graphite rods, a lamp, a pump. This one needs a clear plastic bottle and a sunny day, and it is endorsed by the World Health Organization for exactly that reason. Aftim Acra and colleagues at the American University of Beirut showed in the early 1980s that sunlight in a transparent bottle inactivates the organisms that cause diarrhoeal disease. Two things do the work together: UV-A in the sunlight damages the cells directly, and the heat makes them far more vulnerable to it — above about 45 °C the two effects multiply rather than add. You will run it properly, with a control, and measure the one variable that decides whether it worked.
Cơ bản
1 day

Hướng dẫn

1

Choose the right bottle

Use a clear PET drinks bottle of 2 litres or less, in good condition. Scrub off the label so light reaches the whole volume. Glass is the wrong choice here and the reason is precise: ordinary window and bottle glass blocks most UV-A, which is the part doing the killing. PET passes it. Avoid scratched or cloudy bottles — the haze scatters the light you need — and avoid anything over 2 litres, because light cannot reach the middle of a deeper container.

Vật liệu cho bước này:

Chai nhựa đựng nước giải khát (2 L)Chai nhựa đựng nước giải khát (2 L)2 cái
2

Filter first if the water is cloudy

Hold a filled bottle over a newspaper headline at arm's length. If you can read the text through it, the water is clear enough. If not, it must be settled or filtered first. This is the same shadow problem the UV lamp had, and it is the thread running through the whole batch: a microbe hiding behind a particle of clay receives no dose at all. SODIS has a firm published limit of about 30 NTU turbidity, and the headline test is the field version of it.
3

Fill, aerate, and cap

Fill each bottle three-quarters, shake hard for twenty seconds to drive oxygen into the water, then top up and cap tightly. The shake matters more than it looks. Dissolved oxygen lets the UV-A produce reactive oxygen species inside the cells, and that photo-oxidative damage is a large part of the killing. Water straight from a deep well with little dissolved oxygen disinfects measurably more slowly if you skip this.

Công cụ cần thiết:

Đồng hồ bấm giờĐồng hồ bấm giờ
4

Lay them on metal, not on grass

Put the bottles on their side — never upright — on a corrugated iron roof, or on a board covered with foil, in full sun for six hours. If it is cloudy for more than half the day, leave them for two full days. On their side because a lying bottle presents a short light path and a large sunlit area; upright, the sun has to penetrate the whole depth. On metal because the reflected light adds dose and, more importantly, the hot surface pushes the water past 45 °C where heat and light start multiplying each other. Grass does neither.

Vật liệu cho bước này:

Giấy nhômGiấy nhôm1 cuộn

Công cụ cần thiết:

Nhiệt kếNhiệt kế
5

The temperature and the dose

Đang tải sổ tay Jupyter…

Công cụ cần thiết:

Nhiệt kếNhiệt kế
6

Run a control, or you have measured nothing

Treat two bottles identically except that one is wrapped in foil, completely dark, and sits beside the other all day at the same temperature. Without it you cannot separate what the sun did from what simply sitting in a warm bottle did. This is the whole discipline of the thing: a control is not extra work, it is what turns an afternoon in the sun into a measurement. If you have access to a simple coliform test, run both bottles and the untreated source — three samples, one comparison.

Vật liệu cho bước này:

Giấy nhômGiấy nhôm1 cuộn
Chai nhựa đựng nước giải khát (2 L)Chai nhựa đựng nước giải khát (2 L)1 cái
7

Drink from the bottle it was treated in

Leave the water in its bottle and drink straight from it. Every time you decant treated water into another container you risk putting back what you just spent the day removing — SODIS leaves no residual, so there is nothing to protect it from a dirty cup. Reuse bottles until they go hazy or brittle, then replace them; a scratched bottle passes less UV-A and treats less reliably. Concerns about PET leaching have been tested repeatedly under exactly these conditions and the measured levels sit far below drinking-water limits — a fact worth knowing, because it is the objection this method always meets.

Vật liệu

2

Công cụ yêu cầu

2

Blueprint liên quan

Các blueprint này chia sẻ kiến thức — kỹ thuật, vật liệu hoặc nguyên tắc

CC0 Phạm vi công cộng

Bản thiết kế này được phát hành theo CC0. Bạn tự do sao chép, sửa đổi, phân phối và sử dụng cho bất kỳ mục đích nào mà không cần xin phép.

Hỗ trợ nhà sáng tạo bằng cách mua sản phẩm qua bản thiết kế, nơi họ nhận Hoa hồng nhà sáng tạo do nhà bán hàng đặt, hoặc tạo phiên bản mới và kết nối trong bản thiết kế riêng để chia sẻ doanh thu.

Thảo luận

(0)

Đăng nhập để tham gia thảo luận

Đang tải bình luận...