NGHỆ THUẬT
LÀM ĐẸP VÀ SỨC KHỎE
THỦ CÔNG
VĂN HÓA VÀ LỊCH SỬ
GIẢI TRÍ
MÔI TRƯỜNG
THỰC PHẨM VÀ ĐỒ UỐNG
KỸ THUẬT NGƯỢC
KHOA HỌC
THỂ THAO
CÔNG NGHỆ
THIẾT BỊ ĐEO

The Crutch: Carrying the Body on the Hands
When a leg cannot bear weight, the arms must take it. Crutches are among the oldest aids there are, and their design is a question of mechanics: the load must go through the hands, not the armpit, and the tip must not slide.
The underarm crutch braces against the side of the chest while the hands carry the body weight; leaning on the armpit pad instead compresses the nerves there. The tip's rubber grips only as long as the crutch is not planted too far out — the angle and the floor decide whether it holds.
This rung works out the loads through the hands and the friction the tip needs, gives the standard fitting guide, and measures both on the bench.
Cơ bản
About 2 hours
Hướng dẫn
1
1
Hand loads, tip friction and fitting
Hand loads, tip friction and fitting
Đang tải sổ tay Jupyter…
2
2
The arm that carries the load
The arm that carries the load
On crutches the arms carry the body. The embedded blueprint shows the arm's bones and muscles as a lever system.
3
3
Measure the tip's grip
Measure the tip's grip
Stand a crutch on a floor surface. Holding the handgrip, press down firmly and slowly lean the top away until the tip slips. Measure the angle from vertical with a protractor at the moment it slips; $\mu = \tan\theta$.
Repeat on dry concrete, on tile, on tile wetted with a spray bottle, and with the rubber tip and without it (the bare tube). Tabulate $\mu$. The wet tile and the bare tube are the ones that put people on the floor.
Vật liệu cho bước này:
Nạng1 cái
Bình xịt nước1 cái
Nước1 lítCông cụ cần thiết:
Thước đo góc
Thước kẻ4
4
Fit and load-check a crutch
Fit and load-check a crutch
Adjust the crutch using its spring-button holes: overall length so the pad is about 5 cm below the armpit when standing tall, then the handgrip to wrist-crease height with the arm hanging.
Stand with one foot on a weighing scale and the crutch tip on the floor beside it; take weight off the scale onto the crutch through the hand only, pad clear of the armpit. The drop in the scale reading is the load in the hand. Then let the pad bear on the armpit and feel where the load goes. Do this briefly and on a stable floor — you are testing the crutch, not practising a gait.
Công cụ cần thiết:
Cân
Thước dây cuộn5
5
A crutch that is not working for its user
A crutch that is not working for its user
Crutch problems and their usual causes. A physiotherapist should fit crutches for anyone who needs them.
Flow
Loading...
6
6
Context and honest limits
Context and honest limits
Crutches appear in the art of ancient Egypt and have been used ever since. The adjustable aluminium underarm crutch and the forearm (elbow) crutch, which carries the load on a cuff and handgrip with no armpit pad, are the common forms today.
**Honest limits.** The friction values in the notebook are examples, not measurements; measure your own. The 77 % length rule is a rough starting point. Crutch fitting and gait training are the job of a physiotherapist.
Blueprint liên quan
Các blueprint này chia sẻ kiến thức — kỹ thuật, vật liệu hoặc nguyên tắc
CC0 Phạm vi công cộng
Bản thiết kế này được phát hành theo CC0. Bạn tự do sao chép, sửa đổi, phân phối và sử dụng cho bất kỳ mục đích nào mà không cần xin phép.
Hỗ trợ nhà sáng tạo bằng cách mua sản phẩm qua bản thiết kế, nơi họ nhận Hoa hồng nhà sáng tạo do nhà bán hàng đặt, hoặc tạo phiên bản mới và kết nối trong bản thiết kế riêng để chia sẻ doanh thu.


