
GPS Position Logger
Imiyalelo
Solder the GPS shield headers
Solder the GPS shield headers
The kit contains the shield, an EM-506 receiver with its interface cable, and R3 headers. Solder the headers to the shield.
Izinto zokwakha zalesi sinyathelo:
SparkFun GPS Shield Kit1 ikhithiAmathuluzi adingekayo:
Ryobi ONE+ RSI18-0 Cordless Soldering IronStack both shields and check for pin clashes
Stack both shields and check for pin clashes
Plug the EM-506 into the shield's connector, then stack GPS shield and microSD shield on the Uno.
- GPS shield: receiver on D2/D3 with its switch in the DLINE position.
- microSD shield: SPI on D11/D12/D13, card select on D8.
Izinto zokwakha zalesi sinyathelo:
microSD Shield1 ucezu
Arduino Uno R3 SMD1 ucezuPower, and read raw NMEA before parsing anything
Power, and read raw NMEA before parsing anything
USB-B from the computer while testing; 7–12 V on the barrel jack once it runs standalone.
Before writing any parser, print the receiver's output straight through and look at it. You should see comma-separated sentences beginning with $.
Sentences arriving with empty position fields mean the receiver is alive and talking but has no fix yet. That is the normal cold-start state — not a fault.Izinto zokwakha zalesi sinyathelo:
USB-B Cable1 ucezuUpload the logging sketch
Upload the logging sketch
No GPS library needed — the sketch reads NMEA directly, so nothing is hidden behind an abstraction. SD and SPI ship with the IDE. Format the card FAT32 first.
Take it outside for the first fix
Take it outside for the first fix
Put the unit under open sky, powered, and leave it. Watch for the fix indicator before judging the build.
Testing a GPS receiver indoors and concluding it is broken is the single most common failure in this project. A cold start with no stored almanac legitimately takes minutes.Izinto
5- SparkFun GPS Shield Kitikhomishini engu-10%1 ikhithi$55.51
- microSD Shieldikhomishini engu-10%1 ucezu$14.46
- Arduino Uno R3 SMDikhomishini engu-10%1 ucezu$27.46
- SparkFun Cerberus USB Cable - 1.8 meterikhomishini engu-10%1 ucezu$5.77
- Jumper Wires Premium M/M 20 AWG - 15.5 cm (Pack of 10)ikhomishini engu-10%1 iphakethe$5.08
Amathuluzi Adingekayo
1- Ryobi ONE+ RSI18-0 Cordless Soldering Ironikhomishini engu-3%$94.56
CC0 Isizinda Somphakathi
Le blueprint ikhishwe ngaphansi kwe-CC0. Ukhululekile ukukopisha, ukuguqula, ukusabalalisa, nokusebenzisa ngaphandle kwemvume.
Sekela uMenzi ngokuthenga imikhiqizo nge-Blueprint yabo IKhomishane Yomenzi kumiswe ngabathengisi, noma dala inguqulo entsha yale Blueprint bese uyifaka njengoxhumaniso ku-Blueprint yakho ukuze wabelane ngemali engenayo.