ARTE
BELEZA E BEM-ESTAR
ARTESANATO
CULTURA E HISTÓRIA
ENTRETENIMENTO
MEIO AMBIENTE
COMIDA E BEBIDAS
FUTURO VERDE
ENGENHARIA REVERSA
CIÊNCIAS
ESPORTES
TECNOLOGIA
TECNOLOGIA VESTÍVEL
Egyptian Henna Dye — Preparing Henna Paste for Body Decoration
Bob

Criado por

Bob

23. March 2026

Egyptian Henna Dye — Preparing Henna Paste for Body Decoration

Prepare traditional henna paste from dried Lawsonia inermis leaves, used in ancient Egypt to dye skin, hair, and nails reddish-brown. Henna evidence has been found on mummies dating to 1200 BCE, and the plant was cultivated along the Nile for both its dye and fragrant flowers.

Beginner
30-45 minutes

Instruções

1

Grind the Dried Henna Leaves

Place dried Lawsonia inermis leaves in a stone mortar and grind to a fine powder. Leaves should be bright green when freshly dried — brown or dull-colored leaves indicate age and produce weaker stain. Sieve through fine mesh to remove stems, leaf veins, or coarse particles. The finer the powder, the smoother the paste and the more even the stain. The active dye molecule is lawsone (2-hydroxy-1,4-naphthoquinone), concentrated in leaves at 1-2% by dry weight. This molecule binds to keratin protein in skin, hair, and nails through a Michael addition reaction, producing a permanent reddish-brown stain that fades only as stained cells naturally exfoliate.

2

Mix the Paste with Acidic Liquid

Place sifted henna powder in a non-metallic bowl (metal can react with lawsone). Gradually add lemon juice or mildly acidic liquid (pH 4-5.5) while stirring until the mixture forms thick paste with the consistency of mashed potatoes. The acid breaks down cellulose in leaf cells and releases lawsone from its bound sugar form (hennosides) into free lawsone. Add a tablespoon of sugar to improve skin adhesion without cracking. Optionally, add essential oil containing monoterpene compounds, which enhance lawsone release and skin penetration.

Step 2 - Image 1
3

Allow the Dye to Release

Cover the paste with plastic wrap or damp cloth pressed onto the surface. Allow to rest at room temperature (20-25 degrees Celsius) for 8-12 hours, or in warmth (30-35 degrees Celsius) for 4-6 hours. During this dye release period, lawsone molecules migrate from leaf cells into the liquid phase, becoming available to bind keratin. The paste darkens from bright green to brownish-green. Test by applying a small dot to a fingertip — if it stains orange within 10-15 minutes, dye release is complete. In ancient Egypt's warm climate, dye release would have occurred naturally within a few hours.

4

Apply the Henna Paste

Apply the rested paste to clean, dry skin in desired patterns using a small stick, cone, or brush, in a layer approximately 2-3 mm thick. Ancient Egyptians applied henna to fingernails, palms, soles, and hair. The mummy of Ramesses II showed henna-stained hair, suggesting its use even for pharaohs. The paste must remain moist and in contact with skin for 2-6 hours for light stains, 6-12 hours for deep color. Wrap the pasted area gently to maintain moisture. Body heat and paste moisture drive lawsone molecules into the keratin layer.

5

Remove the Paste and Develop the Stain

Scrape or peel the dried paste off — do not wash with water, as water interferes with the final oxidation stage. The initial stain appears bright orange. Over 24-48 hours, the lawsone-keratin complex oxidizes when exposed to air, deepening to rich reddish-brown or mahogany. The stain on palms and soles (thickest keratin) is darkest and longest-lasting, persisting 2-4 weeks. On thinner skin it fades within 1-2 weeks as epidermal cells naturally shed. Ancient Egyptian women were frequently depicted with reddish fingertips and palms, consistent with regular henna use.

Step 5 - Image 1

Materiais

  • Dried henna leaves (Lawsonia inermis) - 100 g piece
  • Lemon juice or mildly acidic liquid - 150-200 ml piece
  • Sugar - 1 tablespoon pieceReferência
    Ver
  • Essential oil (eucalyptus or tea tree, optional) - 5-10 drops pieceReferência
    Ver

Ferramentas necessárias

  • Stone mortar and pestleReferência
    Ver
  • Fine sieve or clothReferência
    Ver
  • Mixing bowl (non-metallic)Referência
    Ver
  • Plastic wrap or cloth coverReferência
    Ver

CC0 Domínio Público

Este blueprint é liberado sob CC0. Você é livre para copiar, modificar, distribuir e usar este trabalho para qualquer finalidade, sem pedir permissão.

Apoie o Maker comprando produtos através do Blueprint, onde ele ganha uma Comissão Maker definida pelos vendedores, ou crie uma nova versão deste Blueprint e inclua-o como conexão no seu próprio Blueprint para compartilhar receita.

Discussão

(0)

Entrar para participar da discussão

Carregando comentários...