Colaboração
ARTE
BELEZA E BEM-ESTAR
ARTESANATO
CULTURA E HISTÓRIA
ENTRETENIMENTO
MEIO AMBIENTE
COMIDA E BEBIDAS
ENGENHARIA REVERSA
CIÊNCIAS
ESPORTES
TECNOLOGIA
TECNOLOGIA VESTÍVEL
PTFE Sheet: Compact-Extruded Films, Sintered, Laid at 45° and Fused (MacFarland, Hills-McCanna, US 3,130,954)
Charlie

Criado por

Charlie

31. outubro 2026DE
7
0
0
0
0

PTFE Sheet: Compact-Extruded Films, Sintered, Laid at 45° and Fused (MacFarland, Hills-McCanna, US 3,130,954)

Thick PTFE was cut from a sintered billet with a knife, and the skived sheet tore along the knife marks. MacFarland built his sheet up instead, from thin extruded films laid crosswise and fused together, for the liner of a valve diaphragm. Result: a dense PTFE sheet, about 7,000 psi tensile and 450 % elongation, much the same in every direction. Source: MacFarland, US 3,130,954 (Hills-McCanna, 1964). Not given: furnace temperature, mill pressure. Picture drawn by Youblob.
Avançado
Factory process

Instruções

1

Compact-extrude a film

Feed finely divided PTFE resin from a hopper through a screw extruder to a slot die, usually without added heat. It comes out as a compact film that holds together unsintered, up to 24 in wide.

Materiais para este passo:

Pó de resina de PTFEPó de resina de PTFE1 as required

Ferramentas necessárias:

Extrusora de plásticoExtrusora de plástico
Matriz de extrusãoMatriz de extrusão
2

Sinter and coin the film

Carry the film through a sintering furnace to its fusion (gel) state and coin it in a mill as it goes. It comes out dense, with few pores, 5-8 mils thick. Ours: muffle furnace and calender rolls.

Ferramentas necessárias:

Forno muflaForno mufla
Cilindros de calandra lisosCilindros de calandra lisos
3

Lay the films crosswise and fuse them

Each film is a little stronger lengthwise, so stack several with their lengthwise axes turned by the same angle each time; 45° works well (MacFarland shows five plies). Feed the stack into a final sintering and compacting mill to fuse it into one sheet (over 20 mils thick). Ours: muffle furnace and calender rolls.

Ferramentas necessárias:

Forno muflaForno mufla
Cilindros de calandra lisosCilindros de calandra lisos

Materiais

1

Ferramentas necessárias

4

CC0 Domínio Público

Este blueprint é liberado sob CC0. Você é livre para copiar, modificar, distribuir e usar este trabalho para qualquer finalidade, sem pedir permissão.

Apoie o Maker comprando produtos através do Blueprint, onde ele ganha uma Comissão Maker definida pelos vendedores, ou crie uma nova versão deste Blueprint e inclua-o como conexão no seu próprio Blueprint para compartilhar receita.

Discussão

(0)

Entrar para participar da discussão

Carregando comentários...