Colaboração
ARTE
BELEZA E BEM-ESTAR
ARTESANATO
CULTURA E HISTÓRIA
ENTRETENIMENTO
MEIO AMBIENTE
COMIDA E BEBIDAS
ENGENHARIA REVERSA
CIÊNCIAS
ESPORTES
TECNOLOGIA
TECNOLOGIA VESTÍVEL
Steel Dowel Pins: Two from One Piece, Necked, Hardened and Ground (Stanley 1919)
Frank A. Stanley · Public domain (1919)
Forge

Criado por

Forge

27. outubro 2026NO
16
0
0
0
0

Steel Dowel Pins: Two from One Piece, Necked, Hardened and Ground (Stanley 1919)

Die makers made their own dowel pins two at a time: one piece of steel is turned, necked in the middle, hardened, ground dead straight to size from each end, then snapped in two at the neck. Frank Stanley described the practice of one die shop. Source: F. A. Stanley, Punches and Dies (1919), pp. 417–419. The choice of tool steel and the forge for hardening are ours; the passage gives no hardening heat. Picture: Stanley's Fig. 610, grinding dowel pins.
Intermediário
1 day

Instruções

1

Cut stock for two pins

Take a length of steel a little larger than the dowel size and long enough for two pins. It must harden, so use tool steel (our choice).

Materiais para este passo:

Barra octogonal de aço para ferramentasBarra octogonal de aço para ferramentas1 length for two pins

Ferramentas necessárias:

Torno de bancadaTorno de bancada
2

Turn 0.008 in over size

Turn it on centres to about 0.008 in above the finished size.

Ferramentas necessárias:

Torno mecânicoTorno mecânico
Arrastador de tornoArrastador de torno
MicrómetroMicrómetro
3

Neck it in the middle

Cut a neck 1/16 in deep in the middle, the dividing line between the two pins.

Ferramentas necessárias:

Torno mecânicoTorno mecânico
4

Harden

Harden the piece. This passage gives no heat; heat to hardening heat and quench in the usual way for your steel (ours).

Ferramentas necessárias:

Forja de ferreiroForja de ferreiro
TenazesTenazes
Balde de têmperaBalde de têmpera
5

Grind each half to size

Put it on dead centres in the grinding machine and grind the diameter to size from one end to the neck. Reverse it on the centres and grind from the other end. The pins come out perfectly straight from end to end.

Ferramentas necessárias:

Retificadora cilíndricaRetificadora cilíndrica
Arrastador de tornoArrastador de torno
MicrómetroMicrómetro
6

Break the pins apart

Break the piece apart at the neck. You have two dowel pins ground closely to standard size; ream their holes true and straight to fit.

Ferramentas necessárias:

Torno de bancadaTorno de bancada

Materiais

1

Ferramentas necessárias

8

CC0 Domínio Público

Este blueprint é liberado sob CC0. Você é livre para copiar, modificar, distribuir e usar este trabalho para qualquer finalidade, sem pedir permissão.

Apoie o Maker comprando produtos através do Blueprint, onde ele ganha uma Comissão Maker definida pelos vendedores, ou crie uma nova versão deste Blueprint e inclua-o como conexão no seu próprio Blueprint para compartilhar receita.

Discussão

(0)

Entrar para participar da discussão

Carregando comentários...