Colaboração
ARTE
BELEZA E BEM-ESTAR
ARTESANATO
CULTURA E HISTÓRIA
ENTRETENIMENTO
MEIO AMBIENTE
COMIDA E BEBIDAS
ENGENHARIA REVERSA
CIÊNCIAS
ESPORTES
TECNOLOGIA
TECNOLOGIA VESTÍVEL
Tangent Galvanometer: 8 Turns on an 11-Inch Wooden Ring with a Pocket Compass (Boy Mechanic, 1913)
Penny

Criado por

Penny

14. novembro 2026DK
4
0
0
0
0

Tangent Galvanometer: 8 Turns on an 11-Inch Wooden Ring with a Pocket Compass (Boy Mechanic, 1913)

A current meter from a wooden ring wound with eight turns of wire and a pocket compass at its centre: set the coil north-south, pass the current, and the needle's swing gives the amperes from a table (0.5 A at 45 degrees).
Intermediário
An afternoon

Instruções

1

The tangent law

A carregar o notebook Jupyter…
2

Read the Boy Mechanic

"Any deviation from the dimensions will cause errors in the results obtained by its use."
3

Make the ring

From 1/2 in wood cut a ring 10-1/2 in outside and 9 in inside. Glue on each side a 1/4 in ring, 9 in inside and 11 in outside, to form a 1/4 in channel round the edge (or turn it from solid). Use brass screws and brads only.

Materiais para este passo:

Tábua de madeira de leiTábua de madeira de lei1 peça
Cola de madeiraCola de madeira1 peça

Ferramentas necessárias:

Serra de recortesSerra de recortes
BússolaBússola
4

Wind the coil

Wind 8 turns of No. 16 insulated magnet wire in the channel and tie the ends.

Materiais para este passo:

Fio de cobre esmaltadoFio de cobre esmaltado1 peça
FioFio1 peça
5

Base

Cut a round base 11 in across with a slot 1 in wide and 6-5/16 in long in the middle. Stand the ring in it with its inner surface level with the top of the base, held by a small strip screwed to the base. Fit two binding posts and connect the coil ends.

Materiais para este passo:

Tábua de madeira de leiTábua de madeira de lei1 peça
Borne de painelBorne de painel1 peça
Parafusos para madeiraParafusos para madeira1 peça

Ferramentas necessárias:

Serra de recortesSerra de recortes
Arco de pua e brocaArco de pua e broca
6

Mount the compass

Fix two strips 1/4 x 5/8 x 11 in across the ring with their top edges exactly through its centre, and set a pocket compass about 1-1/4 in across in them, needle centre at the ring centre, zero half-way between the strips. Coat everything with brown shellac.

Materiais para este passo:

Tábua de madeira de leiTábua de madeira de lei1 peça
Bússola magnéticaBússola magnética1 peça
Verniz de goma-lacaVerniz de goma-laca1 peça

Ferramentas necessárias:

SerroteSerrote
7

Set up and read

Keep iron, steel and magnets away. On a level table turn it until the needle lies in the plane of the coil at zero. Connect the circuit; 45 degrees means 1/2 ampere; use the table for other angles. His table holds near Chicago and east of it north of the Ohio; multiply by 1.3 south of the Ohio and east of the Mississippi.
8

Troubleshooting

Galvanometer troubleshooting.

Flow

Loading...
9

History and honest limits

From **The Boy Mechanic, Book 1** (Popular Mechanics, 1913), pp. 150-151 (checked on the archive.org scan boymechanic0000unse_n5a8). His table equals 0.5 x tan(angle); the field-strength note and modern enamelled wire are ours.

Materiais

8

Ferramentas necessárias

4

Blueprints relacionados

Estes blueprints compartilham conhecimento — técnicas, materiais ou princípios

CC0 Domínio Público

Este blueprint é liberado sob CC0. Você é livre para copiar, modificar, distribuir e usar este trabalho para qualquer finalidade, sem pedir permissão.

Apoie o Maker comprando produtos através do Blueprint, onde ele ganha uma Comissão Maker definida pelos vendedores, ou crie uma nova versão deste Blueprint e inclua-o como conexão no seu próprio Blueprint para compartilhar receita.

Discussão

(0)

Entrar para participar da discussão

Carregando comentários...