Colaboração
ARTE
BELEZA E BEM-ESTAR
ARTESANATO
CULTURA E HISTÓRIA
ENTRETENIMENTO
MEIO AMBIENTE
COMIDA E BEBIDAS
ENGENHARIA REVERSA
CIÊNCIAS
ESPORTES
TECNOLOGIA
TECNOLOGIA VESTÍVEL
Tonoko: Iron Ochre Pulverized for Japanese Lacquer Groundwork (after Rein 1889)
Charlie

Criado por

Charlie

31. outubro 2026DE
5
0
0
0
0

Tonoko: Iron Ochre Pulverized for Japanese Lacquer Groundwork (after Rein 1889)

Japanese lacquerers build a hard ground under the lacquer from a powder they call to-no-ko. Rein, who studied the workshops in the 1870s, names it plainly: iron ochre powder. Stirred with water to a stiff paste and tempered with raw lacquer, it becomes the kiri-ko and sabi grounds, and the sabi putty of kintsugi. Result: tonoko, iron ochre ground to a fine powder. Source: J. J. Rein, The Industries of Japan (1889), pp. 354 and 358. Rein says only 'pulverized'; mortar and sieve are ours. Picture drawn by Youblob.
Iniciante
2 hours

Instruções

1

Pulverize the ochre

Crush and grind dry iron ochre in a stone mortar. Ours: until it is a fine, even powder.

Materiais para este passo:

Ocre em brutoOcre em bruto1 as required

Ferramentas necessárias:

Almofariz e pilão de pedraAlmofariz e pilão de pedra
2

Sift fine

Ours: pass the powder through a fine sieve and grind the coarse rest again. Keep it dry in a closed jar.

Ferramentas necessárias:

Peneira finaPeneira fina
Frascos de vidro com tampaFrascos de vidro com tampa
3

Check: a stiff paste

A little stirred with water should make a smooth, stiff paste, as for kiri-ko, where it is then tempered with raw lacquer, a little brick dust and paste.

Ferramentas necessárias:

ÁguaÁgua

Materiais

1
  • 1 as required
    Referência

Ferramentas necessárias

4

CC0 Domínio Público

Este blueprint é liberado sob CC0. Você é livre para copiar, modificar, distribuir e usar este trabalho para qualquer finalidade, sem pedir permissão.

Apoie o Maker comprando produtos através do Blueprint, onde ele ganha uma Comissão Maker definida pelos vendedores, ou crie uma nova versão deste Blueprint e inclua-o como conexão no seu próprio Blueprint para compartilhar receita.

Discussão

(0)

Entrar para participar da discussão

Carregando comentários...