Colaboração
ARTE
BELEZA E BEM-ESTAR
ARTESANATO
CULTURA E HISTÓRIA
ENTRETENIMENTO
MEIO AMBIENTE
COMIDA E BEBIDAS
ENGENHARIA REVERSA
CIÊNCIAS
ESPORTES
TECNOLOGIA
TECNOLOGIA VESTÍVEL
Woven Collection Basket: the Oval Willow Linen Basket (Hasluck, 1903)
Woody

Criado por

Woody

4. novembro 2026NO
7
0
0
2
0

Woven Collection Basket: the Oval Willow Linen Basket (Hasluck, 1903)

A large woven willow basket with a handle at each end, for carrying linen or gathered goods: the basket-maker's oval linen basket, with a crowned oval bottom woven on a tied 'slarth', stakes pushed in round it, randed sides 7 in deep at the ends and 2 1/2 in higher at the sides, a wale and a plaited border. About 22 in long. Variable: randed (16 pairs of stakes) or slewed (15 1/2 pairs). Source: Paul N. Hasluck, Basket Work of All Kinds (1903), pp. 55-63. Picture: Fig. 58 of the book.
Avançado
Unknown

Instruções

1

Cut the bottom sticks

For a 14 in bottom cut seven sticks about 12 in long, shaving a little off along the middle, and an 8 in piece of rod to divide the tie-rods. Take eight tie-rods. Up to 14 in use three lays of sticks; larger bottoms need four and thicker sticks.

Materiais para este passo:

Varas de vime mais grossasVaras de vime mais grossas7 12 in
Vime de salgueiroVime de salgueiro8 tie-rods

Ferramentas necessárias:

Tesoura de podar de uma mãoTesoura de podar de uma mão
2

Tie the slarth

On the board, put four tie-rods' butts under the right foot. About 5 in from the ends lay two sticks between A and C and between B and D, then three sticks about 2 3/4 in further on, then the last two, so the three lays fill a 7 in space; slip the 8 in piece under the three middle sticks (Fig. 57). Work the other four rods between the sticks with butts the opposite way (Fig. 58), passing each tightly over and under, tapping them close with the iron and pulling up the sticks each time to crown the bottom. Lay the slarth about half the finished length.

Ferramentas necessárias:

Tábua de madeira planaTábua de madeira plana
MarteloMartelo
3

Open the sticks and pair the bottom

Work the tie-rod tops round in pairs, opening the sticks into separate groups. Point a handful of rods at the butt, wet the points, and pair them in, thinnest and shortest first, one rod under and over the other, starting at either side, until the bottom is 14 in long. Finish the last pair in and out of the pairing, pick off the ends and cut off the stick ends with the shears.

Materiais para este passo:

Vime de salgueiroVime de salgueiro1 pairing rods

Ferramentas necessárias:

Tesoura de podar de uma mãoTesoura de podar de uma mão
TesourãoTesourão
ÁguaÁgua
4

Stake up and upset

Cut stakes as for a round basket: 16 pairs for a randed basket, 15 1/2 for a slewed one. Push them in, a pair beside each stick, turn the bottom over and press it down, prick up each stake and gather them in a large hoop; drive them in close. Upset with four rods, each in front of three stakes and behind the fourth, and add a second round.

Materiais para este passo:

Estacas de salgueiroEstacas de salgueiro32 16 pairs
Vime de salgueiroVime de salgueiro1 upsetting

Ferramentas necessárias:

Passador de fitasPassador de fitas
Tesoura de podar de uma mãoTesoura de podar de uma mão
MarteloMartelo
5

Rand the sides and wale

Free the end stakes from the hoop: the top needs a good 8 in spring from end to end. Work a few short pieces at each side first, ends left outside so the inside stays smooth, then rand round to the right until the ends are 7 in high and the basket measures 22 in end to end. Raise the sides about 2 1/2 in higher than the ends. Work a wale of three rods (inside two stakes, outside one) or four (inside two, outside two).

Materiais para este passo:

Vime de salgueiroVime de salgueiro1 randing, wale

Ferramentas necessárias:

MarteloMartelo
ÁguaÁgua
6

Border and handles

Begin the border by laying down five rods, each worked in front of four stakes and behind two; finish by cramming and trim with the picking knife. For each end handle push in two rods beside stakes three or four apart; bend one into a bow under the border, twist the other rope-fashion and lap it over the bow three times each way, then lap the bow rod's own top across it.

Materiais para este passo:

Vime de salgueiroVime de salgueiro9 5 border rods, 4 handle rods

Ferramentas necessárias:

Passador de fitasPassador de fitas
Tesoura de podar de uma mãoTesoura de podar de uma mão

Materiais

3

Ferramentas necessárias

6

CC0 Domínio Público

Este blueprint é liberado sob CC0. Você é livre para copiar, modificar, distribuir e usar este trabalho para qualquer finalidade, sem pedir permissão.

Apoie o Maker comprando produtos através do Blueprint, onde ele ganha uma Comissão Maker definida pelos vendedores, ou crie uma nova versão deste Blueprint e inclua-o como conexão no seu próprio Blueprint para compartilhar receita.

Discussão

(0)

Entrar para participar da discussão

Carregando comentários...