Making a Color-Changing LilyPad Patch

Sew a patch that glows in any color. A single RGB LED holds red, green and blue elements; by fading each one with the microcontroller's PWM pins you mix millions of colors and cycle through the rainbow. The e-textile version of the classic RGB colour-mixing project.

中级

1-2 hours

说明

Sew the board and RGB LED

Sew a LilyPad Arduino onto felt. The RGB LED has four legs — bend each into a small loop so it can be sewn. Wire the common cathode (the longest leg) to -, and the red, green and blue legs to pins 5, 6 and 9. Keep the four lines from touching each other.

此步骤所需材料：

LilyPad Arduino Simple Board1 个

LED - RGB Diffused Common Cathode - 5mm1 个

Conductive Thread - 60g (Stainless Steel)1 轴

Hand Sewing Needles (Assorted, 30-Pack)1 包

Wool Felt Sheet1 张

Connect the programmer

Plug the LilyPad FTDI onto the programming header and connect the USB cable. Open the Arduino IDE and select the LilyPad Arduino board and its serial port.

此步骤所需材料：

LilyPad FTDI Basic Breakout - 5V1 个

SparkFun Cerberus USB Cable - 1.8 meter1 个

所需工具：

Computer with Arduino IDE

Upload the color-mixing sketch

Paste this sketch and upload. It fades the LED through red, green, blue and the mixes using analogWrite (PWM).

lilypad_color_changing.inoarduino

// Mix colors on a common-cathode RGB LED.
// Red/Green/Blue legs on PWM pins 5, 6, 9; common cathode to - (GND).

const int RED_PIN = 5;
const int GREEN_PIN = 6;
const int BLUE_PIN = 9;

void setColor(int r, int g, int b) {
  analogWrite(RED_PIN, r);     // 0 = off, 255 = full
  analogWrite(GREEN_PIN, g);
  analogWrite(BLUE_PIN, b);
}

void setup() {
  pinMode(RED_PIN, OUTPUT);
  pinMode(GREEN_PIN, OUTPUT);
  pinMode(BLUE_PIN, OUTPUT);
}

void loop() {
  setColor(255, 0, 0);   delay(500);  // red
  setColor(0, 255, 0);   delay(500);  // green
  setColor(0, 0, 255);   delay(500);  // blue
  setColor(255, 255, 0); delay(500);  // yellow
  setColor(0, 255, 255); delay(500);  // cyan
  setColor(255, 0, 255); delay(500);  // magenta
  setColor(255, 255, 255); delay(500);// white
}

Watch it cycle, then mix your own

The LED fades through the colors on its own. Make your own by changing the three numbers in setColor(red, green, blue) — each 0–255. Note: at the LilyPad's lower voltage blue and green look a little dimmer than red, which is normal for RGB LEDs.

Go wireless and wear it

Plug a 3.7 V LiPo into the LilyPad Arduino's JST connector and switch on — the higher voltage also makes the colors brighter. Sew the felt onto a bag or costume for a colour-changing glow.

此步骤所需材料：