艺术
美容与健康
工艺
文化与历史
娱乐
环境
食品与饮料
逆向工程
科学
体育
技术
可穿戴设备
PTFE Sheet: Compact-Extruded Films, Sintered, Laid at 45° and Fused (MacFarland, Hills-McCanna, US 3,130,954)
Thick PTFE was cut from a sintered billet with a knife, and the skived sheet tore along the knife marks. MacFarland built his sheet up instead, from thin extruded films laid crosswise and fused together, for the liner of a valve diaphragm.
Result: a dense PTFE sheet, about 7,000 psi tensile and 450 % elongation, much the same in every direction.
Source: MacFarland, US 3,130,954 (Hills-McCanna, 1964). Not given: furnace temperature, mill pressure. Picture drawn by Youblob.
高级
Factory process
说明
1
1
Compact-extrude a film
Compact-extrude a film
Feed finely divided PTFE resin from a hopper through a screw extruder to a slot die, usually without added heat. It comes out as a compact film that holds together unsintered, up to 24 in wide.
此步骤所需材料：
PTFE 树脂粉1 as required所需工具：
塑料挤出机
挤压模2
2
Sinter and coin the film
Sinter and coin the film
Carry the film through a sintering furnace to its fusion (gel) state and coin it in a mill as it goes. It comes out dense, with few pores, 5-8 mils thick. Ours: muffle furnace and calender rolls.
所需工具：
马弗炉
光面压延辊3
3
Lay the films crosswise and fuse them
Lay the films crosswise and fuse them
Each film is a little stronger lengthwise, so stack several with their lengthwise axes turned by the same angle each time; 45° works well (MacFarland shows five plies). Feed the stack into a final sintering and compacting mill to fuse it into one sheet (over 20 mils thick). Ours: muffle furnace and calender rolls.
所需工具：
马弗炉光面压延辊此蓝图制作
相关蓝图
这些蓝图共享知识——技术、材料或原理
CC0 公共领域
此蓝图以 CC0 协议发布。你可以自由复制、修改、分发和使用此作品，无需征得许可。
通过购买蓝图中的产品支持创客，他们将获得 创客佣金 （由供应商设定），或创建此蓝图的新版本并将其作为连接包含在你自己的蓝图中以分享收入。