KUNST
SCHÖNHEIT & WELLNESS
HANDWERK
KULTUR & GESCHICHTE
UNTERHALTUNG
UMFELD
ESSEN & GETRÄNKE
GRÜNE ZUKUNFT
REVERSE ENGINEERING
WISSENSCHAFTEN
SPORT
TECHNOLOGIE
WEARABLES
Building a Langspil — The Icelandic Drone Zither
Woody

Erstellt von

Woody

3. Juli 2026NO
2
0
0
0
0

Building a Langspil — The Icelandic Drone Zither

Build Iceland's traditional drone zither: a long wooden soundbox with one fretted melody string and two drone strings that ring constantly beneath the tune, so a single player makes melody and harmony at once. A serious maker build in the drone zither and how a soundbox amplifies strings.
Fortgeschritten
Several hours over a few sessions

Anweisungen

1

Melody and drone from one box

The langspil is Iceland's drone zither: a long soundbox with one fretted melody string and one or two drone strings that ring under every note, so one player sounds a tune AND its harmony at once.
2

Cut the soundbox parts

Cut a base, two side ribs and two end blocks for a long, narrow box about 80 cm long and 8-10 cm wide. Icelanders used driftwood — pine, birch or oak.

Materialien für diesen Schritt:

Baltic Birch Plywood (1/8 inch, 12x12, 10-Pack)Baltic Birch Plywood (1/8 inch, 12x12, 10-Pack)1 Stück

Benötigte Werkzeuge:

HacksawHacksaw
3

Glue the box frame

Glue the two ribs to the base and end blocks to make a long, shallow open box. Clamp it and let the glue set fully.

Materialien für diesen Schritt:

PVA Wood GluePVA Wood Glue1 Stück
4

Fit the soundboard

Glue a thin softwood soundboard over the top, overlapping the ribs slightly, to seal a resonant chamber. A thin, light top vibrates best.

Materialien für diesen Schritt:

Dry Softwood BoardDry Softwood Board1 Stück
PVA Wood GluePVA Wood Glue1 Stück
5

Cut a soundhole

Cut a round soundhole in the soundboard so the sound built up inside the box can escape.

Benötigte Werkzeuge:

Sloyd Carving KnifeSloyd Carving Knife
6

Drill the peg holes

At the headstock end, bore three tapered holes through the top for the tuning pegs — one for the melody string, two for the drones.

Benötigte Werkzeuge:

AwlAwl
7

Fit the tuning pegs

Push a friction tuning peg into each hole so it turns stiffly and holds string tension without slipping.

Materialien für diesen Schritt:

Tuning PegsTuning Pegs3 Stück
8

Carve the nut and bridge

Carve a small hardwood nut near the pegs and a low bridge near the far end. The strings ride over both, lifted clear of the soundboard.

Benötigte Werkzeuge:

Sloyd Carving KnifeSloyd Carving Knife
9

String it

Anchor three steel strings to small pins at the far end, run them over the bridge and nut, and wind each onto its tuning peg.

Materialien für diesen Schritt:

Steel Music WireSteel Music Wire1 Stück
10

Set the frets

Fit small metal frets across the soundboard UNDER THE MELODY STRING ONLY, spaced so pressing behind each one gives the next note of a diatonic scale.

Materialien für diesen Schritt:

Fret WireFret Wire1 Stück

Benötigte Werkzeuge:

Metal FileMetal File
11

Tune the drones

Tune the two drone strings to a low keynote and its octave or fifth. They will sound continuously, giving the langspil its droning voice.
12

Tune the melody string

Tune the melody string to the keynote too. Check it against the frets — pressing behind each fret should climb cleanly through the scale.
13

Play it

Press the melody string behind the frets with one hand and pluck it with the other. The drones ring under every note. Try bowing or gently hammering it too.
14

Compendium — the drone zither

The langspil is a drone zither: a resonant box with strings stretched along the top. One fretted MELODY string carries the tune while one or two DRONE strings hold a constant note, so a single player produces melody and harmony together — the same principle as a bagpipe's chanter over its drones, or a hurdy-gurdy. The sealed soundbox is a resonator: the thin strings alone move almost no air, but they shake the light soundboard, which drives the air inside the box, which spills out through the soundhole — the box amplifies the strings, exactly as in a guitar or violin. String pitch follows the same three rules as the musical bow — tension, length and mass — and pressing the melody string just behind a fret shortens its speaking length to raise the pitch by a fixed step, which is the whole point of the frets. Iceland has few trees, so langspils were built from driftwood — pine, birch, oak; the instrument is first recorded in the 18th century and is a northern cousin of the German scheitholt and the Appalachian dulcimer, all box drone zithers. Icelandic schoolchildren still build and play their own today, some laser-cut from plywood in a Fab Lab — a heritage instrument kept alive by making it.

Materialien

6

Benötigte Werkzeuge

4

You can swap these in

Can't get one of the materials? Swap it for an equivalent — these work just as well.

Verwandte Blueprints

Diese Blueprints teilen Wissen — Techniken, Materialien oder Prinzipien

CC0 Gemeinfrei

Dieser Blueprint ist unter CC0 veröffentlicht. Sie dürfen dieses Werk für jeden Zweck frei kopieren, ändern, verbreiten und verwenden, ohne um Erlaubnis zu fragen.

Unterstützen Sie den Maker, indem Sie Produkte über seinen Blueprint kaufen, wo er eine Maker-Provision von Anbietern festgelegt, verdient. Oder erstellen Sie eine neue Iteration dieses Blueprints und verbinden Sie ihn in Ihrem eigenen Blueprint, um Einnahmen zu teilen.

Diskussion

(0)

Anmelden um an der Diskussion teilzunehmen

Kommentare werden geladen...