ARTE
BELLEZA Y BIENESTAR
ARTESANÍA
CULTURA E HISTORIA
ENTRETENIMIENTO
MEDIO AMBIENTE
COMIDA Y BEBIDAS
INGENIERÍA INVERSA
CIENCIAS
DEPORTES
TECNOLOGÍA
TECNOLOGÍA VESTIBLE

Condenser Worm: Copper Tube Coiled in a Water Tub
A still's vapour becomes liquid again in the worm: a copper tube coiled in a tub of cold water. Ure (1839) describes copper stills with a capital and worm, and retorts piped to a worm-tub. Fill copper tube with dry sand so it bends without kinking, wind it round a wooden drum with a steady fall, and set it in a tub with the outlet through the side near the bottom.
The picture: our diagram, the worm in its tub, vapour in at the top and liquid out at the bottom.
Intermedio
A day
Instrucciones
1
1
Fill the tube
Fill the tube
Cork one end of the copper tube, fill it with dry sand tamped down, and cork the other end.
Materiales para este paso:
Tubo de cobre8 m
Arena2 kg
Corchos2 piezasHerramientas necesarias:
Mazo de madera2
2
Wind the coil
Wind the coil
Saw a log into a drum about 30 cm across (our size). Anneal the tube in the fire if it is stiff, then wind it slowly round the drum, letting each turn fall about 5 cm, so the liquid always runs downhill.
Materiales para este paso:
Troncos de madera dura (roble, arce, haya)1 piezaHerramientas necesarias:
Serrucho
Fragua de herrero
Guantes resistentes al calor3
3
Empty the sand
Empty the sand
Slide the coil off the drum, pull the corks and shake and wash out all the sand.
Materiales para este paso:
Agua5 litrosHerramientas necesarias:
Cubo4
4
Set it in the tub
Set it in the tub
Drill the tub near its bottom for the outlet, pass the lower end out through it and seal the hole with a cork and tallow. Fill the tub with cold water; renew the water as it warms.
Materiales para este paso:
Corchos1 pieza
Grasa animal (sebo)0.05 kg
Agua100 litrosHerramientas necesarias:
Cuba
Taladro de mano5
5
Tube for the coil
Tube for the coil
Cargando el cuaderno de Jupyter…
Materiales
6- Marcador de posición
- 2 kgMarcador de posición
- 2 piezasMarcador de posición
- Marcador de posición
- 105 litrosMarcador de posición
- 0.05 kgMarcador de posición
Este plano hace
Blueprints relacionados
Estos blueprints comparten conocimiento — técnicas, materiales o principios
CC0 Dominio público
Este Blueprint se publica bajo CC0. Eres libre de copiar, modificar, distribuir y usar este trabajo para cualquier propósito, sin pedir permiso.
Apoya al Maker comprando productos a través de su Blueprint, donde gana una Comisión del Maker establecida por los vendedores, o crea una nueva iteración de este Blueprint e inclúyela como conexión en tu propio Blueprint para compartir ingresos.


