ARTE
BELLEZA Y BIENESTAR
ARTESANÍA
CULTURA E HISTORIA
ENTRETENIMIENTO
MEDIO AMBIENTE
COMIDA Y BEBIDAS
INGENIERÍA INVERSA
CIENCIAS
DEPORTES
TECNOLOGÍA
TECNOLOGÍA VESTIBLE
Fleshing Beam from a Rounded Half-Log
Woody

Creado por

Woody

14. octubre 2026NO
12
0
0
0
0

Fleshing Beam from a Rounded Half-Log

Hides are laid over a beam and scraped: the hair side with a blunt unhairing knife, the flesh side with a sharp fleshing knife. Shave the flat side of a half-log into a smooth round back, and set it sloping on two legs so the top end stands at the worker's hip. The picture: our diagram of the beam on its legs.
Principiante
Half a day

Instrucciones

1

Round the back

Lay the half-log flat side down. Shave off the bark and round the top with the drawknife, then smooth it with the spokeshave so there are no ridges to cut the hide.

Materiales para este paso:

Medio rollo de madera duraMedio rollo de madera dura1 pieza

Herramientas necesarias:

Cuchilla de dos mangosCuchilla de dos mangos
Cuchilla de dos manosCuchilla de dos manos
2

Legs

Saw two legs from shafts. Drill two splayed holes into the underside near one end and drive the legs in, wedged tight.

Materiales para este paso:

Vara recta de maderaVara recta de madera2 piezas

Herramientas necesarias:

SerruchoSerrucho
Taladro de manoTaladro de mano
Mazo de maderaMazo de madera
ReglaRegla
3

Smooth and set up

Sand the top end smooth, stand the beam with its low end on the ground, and trim the legs until the top sits at hip height.

Herramientas necesarias:

Papel de lijaPapel de lija
SerruchoSerrucho
ReglaRegla
4

Slope

Cargando el cuaderno de Jupyter…

Materiales

2

Herramientas requeridas

7

CC0 Dominio público

Este Blueprint se publica bajo CC0. Eres libre de copiar, modificar, distribuir y usar este trabajo para cualquier propósito, sin pedir permiso.

Apoya al Maker comprando productos a través de su Blueprint, donde gana una Comisión del Maker establecida por los vendedores, o crea una nueva iteración de este Blueprint e inclúyela como conexión en tu propio Blueprint para compartir ingresos.

Discusión

(0)

Iniciar sesión para unirte a la discusión

Cargando comentarios...