Kolaborasi
SENI
KECANTIKAN & KESEHATAN
KERAJINAN
BUDAYA & SEJARAH
HIBURAN
LINGKUNGAN
MAKANAN & MINUMAN
REKAYASA BALIK
ILMU PENGETAHUAN
OLAHRAGA
TEKNOLOGI
PERANGKAT PAKAI
DC Power Supply: SCR-Regulated, Voltage and Current Bridges with Automatic Cross-Over (Kupferberg & Ash, Forbro, US 3,305,763, 1967)
Ed

Dibuat oleh

Ed

3. November 2026FI
8
0
0
0
0

DC Power Supply: SCR-Regulated, Voltage and Current Bridges with Automatic Cross-Over (Kupferberg & Ash, Forbro, US 3,305,763, 1967)

A variable DC supply regulated by controlled rectifiers instead of a series transistor. Two of the four rectifiers in the bridge are silicon controlled rectifiers; how late in each half-cycle they are fired sets the output. A voltage bridge and a current bridge each make an error signal, an analog OR gate passes whichever is larger, and the supply crosses over automatically between holding the voltage and holding the current. Result: a variable voltage / current regulated DC supply with automatic cross-over. Source: K. Kupferberg and J. Ash (Forbro Design), US 3,305,763 (1967), Fig. 1. Unknown: component values and the firing-angle circuit. Picture: the patent drawing.
Lanjutan
Unknown

Instruksi

1

Build the controlled rectifier bridge

In a case, wire the cord through a switch and fuse to a transformer. Feed its secondary into a bridge of two ordinary rectifiers and two silicon controlled rectifiers. Smooth the negative output through a choke and a capacitor, then through a current-sensing resistor (with a second capacitor forming a further filter) to the negative output terminal; the positive goes straight to the positive terminal. Ours: the case, switch and fuse. Not given: the ratings.

Material untuk langkah ini:

Kotak pelindung aluminiumKotak pelindung aluminium1 buah
Kabel lentur berstekerKabel lentur bersteker1 buah
Sakelar tuasSakelar tuas1 buah
SekringSekring1 buah
Trafo Penurun TeganganTrafo Penurun Tegangan1 buah
DiodaDioda2 buah
Tiristor (SCR)Tiristor (SCR)2 buah
Choke filterChoke filter1 buah
Kapasitor elektrolitKapasitor elektrolit2 buah
Terminal panelTerminal panel2 output + and -

Alat yang dibutuhkan:

Bor tanganBor tangan
Set obengSet obeng
2

Build the two bridges

Current bridge: the sensing resistor, a reference Zener, a fixed resistor and the variable current-control resistor. Voltage bridge: the load across the output, the variable voltage-control resistor, a fixed resistor and a second reference Zener. Feed both Zeners from a small separate supply. Not given: the values, the Zener supply.

Material untuk langkah ini:

Dioda ZenerDioda Zener2 buah
ReostatReostat2 voltage and current controls
HambatanHambatan1 sensing and bridge resistors

Alat yang dibutuhkan:

SolderSolder
3

Build the control chain and use it

Invert the current bridge's error in a phase-reversing amplifier and feed it, with the voltage bridge's error, to an analog OR gate that passes the larger. Amplify the result and feed it to a firing-angle control circuit that fires the two controlled rectifiers' gates later or earlier in each half-cycle. In use, set the voltage and the current: for any load larger than the cross-over resistance (voltage setting divided by current setting) the supply holds the voltage, for a smaller one the current. Not given: the amplifier, OR-gate and firing circuits in this form.

Material untuk langkah ini:

Papan sirkuit cetakPapan sirkuit cetak1 buah
Aneka transistorAneka transistor1 amplifiers
Bahan tidak diketahuiBahan tidak diketahui1 OR gate and firing-angle circuit
Kawat Timah SolderKawat Timah Solder1 as needed

Alat yang dibutuhkan:

SolderSolder

Bahan

17
  • Placeholder
  • Placeholder
  • 1 buah
    1 vendor sell this, none ship to you yet
    Placeholder
  • 1 buah
    Placeholder
  • Placeholder
  • 2 buah
    Placeholder
  • Placeholder
  • Placeholder
  • Placeholder
  • 2 output + and -
    2 vendors sell this, none ship to you yet
    Placeholder
  • Placeholder
  • 2 voltage and current controls
    Placeholder
  • 1 sensing and bridge resistors
    Placeholder
  • Placeholder
  • 1 amplifiers
    Placeholder
  • 1 OR gate and firing-angle circuit
    Placeholder
  • Placeholder

Alat yang Diperlukan

3
  • Placeholder
  • Placeholder
  • 2 vendors sell this, none ship to you yet
    Placeholder

CC0 Domain Publik

Cetak biru ini dirilis di bawah CC0. Anda bebas untuk menyalin, memodifikasi, mendistribusikan, dan menggunakan karya ini untuk tujuan apa pun, termasuk komersial, tanpa meminta izin.

Dukung Maker dengan membeli produk melalui Cetak Biru mereka di mana mereka mendapatkan Komisi Pembuat yang ditetapkan oleh Penjual, atau buat iterasi baru dari Cetak Biru ini dan masukkan sebagai koneksi di milik Anda sendiri.

Diskusi

(0)

Masuk untuk bergabung dengan diskusi

Memuat komentar...