هنر
زیبایی و سلامت
صنایع دستی
فرهنگ و تاریخ
سرگرمی
محیط زیست
غذا و نوشیدنی
مهندسی معکوس
علوم
ورزش
فناوری
پوشیدنی‌ها
Electricity From the Wind: The Cube Law and a Rotor on a Dynamo
Volt

ایجاد شده توسط

Volt

27. سپتامبر 2026SE
۴
۰
۰
۰
۰

Electricity From the Wind: The Cube Law and a Rotor on a Dynamo

For a thousand years windmills ground grain and pumped water. In the winter of 1887–88 Charles F. Brush put one to a new job in the back garden of his house in Cleveland, Ohio: a 17-metre rotor of 144 cedar blades turning a dynamo that charged a cellar full of batteries — electricity from the wind. Everything about a wind generator follows from one relation: the power in the wind goes with the cube of its speed and the square of the rotor's diameter. That is why turbines grew huge and why their sites are chosen with such care. This rung builds a small wind generator from a hobby motor and a printed rotor, measures its power in front of a fan at several wind speeds, and checks the cube law.
مبتدی
About 4 hours

دستورالعمل‌ها

1

The cube law

در حال بارگذاری دفترچهٔ Jupyter…
2

Build a small wind generator

A small permanent-magnet DC motor is also a generator: turn its shaft and it makes a voltage proportional to speed. Print a three-bladed rotor 300 mm across in PETG, with a hub that presses onto the motor shaft, each blade twisted — steep near the hub, flatter towards the tip — because the tip moves faster through the air than the root. Mount the motor on a dowel mast clamped to a plywood base, with the rotor facing the fan. Wire the motor's terminals to a 330 Ω resistor as a load, with the multimeter across it. Add an LED in series if you want to see it light.

مواد مورد نیاز این مرحله:

Hobby Motor - GearHobby Motor - Gear1 قطعه
فیلامنت PETGفیلامنت PETG60 گرم
میخ‌های چوب سختمیخ‌های چوب سخت1 مجموعه
ورق تخته‌سه‌لاورق تخته‌سه‌لا1 ورق
مقاومت ۳۳۰ اهممقاومت ۳۳۰ اهم1 قطعه
ال‌ای‌دی ۵ میلی‌متریال‌ای‌دی ۵ میلی‌متری1 قطعه
سیم رابطسیم رابط1 مجموعه

ابزارهای مورد نیاز:

چاپگر سه‌بعدی رشته‌ای (FDM)چاپگر سه‌بعدی رشته‌ای (FDM)
دریل شارژیدریل شارژی
مجموعه متهمجموعه مته
مجموعه آچار آلنمجموعه آچار آلن
3

Measure its power at three wind speeds

Stand the box fan 1.5 m away, facing the rotor. Measure the wind speed at the rotor with the anemometer before fitting the rotor, at each fan setting. Fit the rotor, run the fan, and read the voltage across the resistor once it is steady. The electrical power is **V² ÷ R**. Record wind speed and power for each fan setting. Plot power against wind speed cubed. It should be roughly a straight line — not exactly, because a small motor's own losses take a bigger share at low speed. Then divide your power by the notebook's power passing through a 0.3 m disc at the same wind speed. That ratio is your rotor's power coefficient, and the Betz rung shows the most it could ever be.

ابزارهای مورد نیاز:

پنکهٔ جعبه‌ای (سرعت متغیر)پنکهٔ جعبه‌ای (سرعت متغیر)
بادسنج دستیبادسنج دستی
مولتی‌مترمولتی‌متر
متر نواریمتر نواری
دورسنج دیجیتالدورسنج دیجیتال
4

History and context

**Charles F. Brush, Cleveland, Ohio, 1887–88** — a 17 m, 144-bladed rotor on a tower about 18 m (60 ft) high driving a 12 kW dynamo through step-up gearing, charging batteries that lit his house; it ran for some twenty years. Brush had already built the arc-lighting dynamo in this catalogue. No patent number is asserted here. In Denmark from 1891, **Poul la Cour** tested rotors in a wind tunnel of his own and found that fewer blades turning faster made better use of the wind than many slow ones — the direction every modern turbine took. **Honest limits.** The wind stops; a wind generator needs storage or another source behind it. Its output swings with the cube of a quantity that changes by the minute. And a large rotor is a serious hazard: it must be able to stop itself in a storm, as the Halladay windmill's governor in this catalogue already could.

مواد

7

ابزارهای لازم

9
مجموع تخمینی
آنچه سازنده خریده است. موادی که بدون قیمت نشان داده شده‌اند را از هر جا که بخرید تهیه می‌کنید.
$2.53

CC0 مالکیت عمومی

این نقشه تحت مجوز CC0 منتشر شده است. شما آزاد هستید آن را کپی، ویرایش، توزیع و برای هر هدفی بدون نیاز به اجازه استفاده کنید.

با خرید محصولات از طریق نقشه از سازنده حمایت کنید و او کمیسیون سازنده تعیین شده توسط فروشندگان، دریافت می‌کند یا یک نسخه جدید از این نقشه ایجاد کنید و آن را به عنوان اتصال در نقشه خود قرار دهید تا درآمد به اشتراک گذاشته شود.

بحث و گفتگو

(0)

ورود برای شرکت در بحث

در حال بارگذاری نظرات...