LIST
FEGURÐ OG VELLÍÐAN
HANDVERK
MENNING OG SAGA
SKEMMTUN
UMHVERFI
MATUR OG DRYKKUR
ÖFUGVERKFRÆÐI
VÍSINDI
ÍÞRÓTTIR
TÆKNI
KLÆÐANLEG TÆKNI
Bone Folder Cut from a Leg Bone
Quill

Búin til af

Quill

14. október 2026DE
18
0
0
0
0

Bone Folder Cut from a Leg Bone

A bone folder is a dull-edged tool for folding and creasing paper in bookbinding; traditionally it is cut from the leg bone of a cow or deer, which leaves little residue on the paper. Clean a leg bone, saw a strip from the thick wall of its shaft, shape one end round and the other to a blunt point, and smooth and polish it. The picture: two bone folders, one straight and one tapered.
Byrjandi
An afternoon

Leiðbeiningar

1

Clean the bone

Simmer the leg bone in water until the meat and fat come away, scrub it, and let it dry for several days.

Efni fyrir þetta skref:

BeinBein1 stykki
VatnVatn5 lítrar

Nauðsynleg verkfæri:

JárnketillJárnketill
EldgryfjaEldgryfja
2

Saw a strip

Saw off the knobbly ends, then saw a strip about 2.5 cm wide and 15–20 cm long lengthways from the thick wall of the shaft. Wear a mask; bone dust is fine.

Nauðsynleg verkfæri:

LaufsögLaufsög
SkrúfstykkiSkrúfstykki
RykgrímaRykgríma
3

Shape it

File the strip flat on both faces, round one end and taper the other to a blunt point. Keep every edge dull. Drill a small hole for a hanging cord if you like.

Nauðsynleg verkfæri:

MálmþjölMálmþjöl
SkrúfstykkiSkrúfstykki
HandborHandbor
4

Smooth and polish

Sand it smooth with finer and finer paper, then rub it on the strop until it is glossy and slides over paper without catching.

Nauðsynleg verkfæri:

SandpappírSandpappír
LeðurstrokkariLeðurstrokkari
5

Strips from one bone

Hleð Jupyter-vinnubók…

Efni

2
  • 1 stykki
    Staðgengill
  • 5 lítrar
    Staðgengill

Nauðsynleg verkfæri

9

Tengd Blueprint

Þessi blueprint deila þekkingu — tækni, efni eða meginreglur

CC0 opinbert ríki

Þessi teikning er gefin út undir CC0. Þér er frjálst að afrita, breyta, dreifa og nota þetta verk í hvaða tilgangi sem er, án þess að biðja um leyfi.

Studdu smiðinn með því að kaupa vörur í gegnum teikningu hans þar sem hann fær þóknun smiða sem seljendur ákvarða, eða búðu til nýja endurskoðun á þessari teikningu og tengdu hana sem tengingu í þinni eigin teikningu til að deila tekjum.

Umræða

(0)

Skrá inn til að taka þátt í umræðunni

Hleður athugasemdum...