LIST
FEGURÐ OG VELLÍÐAN
HANDVERK
MENNING OG SAGA
SKEMMTUN
UMHVERFI
MATUR OG DRYKKUR
ÖFUGVERKFRÆÐI
VÍSINDI
ÍÞRÓTTIR
TÆKNI
KLÆÐANLEG TÆKNI
Carbon Steel Strip: Saw Plate Sheared and Annealed Soft
Thin carbon steel strip, soft enough to punch, file and score: the stock for utility-knife blades, hacksaw blades and hole saws, which are hardened only after they are shaped. Start from crucible steel rolled to gauge, cut it into strips with plate shears, then anneal it the way Harcourt's Elementary Forge Practice (1920) gives for tool steel: cherry red, about 1400 °F, and buried in perfectly dry ashes until cold.
Cutting strips instead of saw outlines and the file test are ours. The picture is our drawing.
Byrjandi
1 day (cooling overnight)
Leiðbeiningar
1
1
Roll the plate
Roll the plate
Roll crucible steel to the gauge the blades need, as in this blueprint. Stop before the saw outlines are sheared.
2
2
Mark the strips
Mark the strips
Scribe lines along the plate, one strip width apart. The width is whatever the blades need (ours).
Efni fyrir þetta skref:
Sagarblaðastál í plötum1 stykkiNauðsynleg verkfæri:
Rissnál
Réttskeið3
3
Shear into strips
Shear into strips
Cut along the lines with plate shears, as Grimshaw's saw plates are cut to outline after rolling.
Nauðsynleg verkfæri:
Plötuklippur4
4
Fill a bucket with dry ash
Fill a bucket with dry ash
Fill an iron bucket with ashes. They must be perfectly dry, so they conduct heat poorly and the steel cools slowly. Dry slaked lime also works.
Nauðsynleg verkfæri:
Harðviðaraska
Málmfata5
5
Heat to cherry red
Heat to cherry red
Heat the strips evenly in the forge to a cherry red, about 1400 °F (760 °C). No hotter: overheated steel goes coarse in the grain and weak.
Nauðsynleg verkfæri:
Smiðjueldstæði
Járnsmiðstöng
Suðuhanskar6
6
Bury and leave until cold
Bury and leave until cold
Bury the strips in the ash at once and leave them until they are entirely cold, overnight. The slower they cool, the softer they are.
Nauðsynleg verkfæri:
JárnsmiðstöngMálmfataSuðuhanskar7
7
Check it is soft
Check it is soft
Brush off the ash and stroke a corner with a file: it should bite easily. If it skates, anneal again (our test).
Nauðsynleg verkfæri:
MálmþjölEfni
1- 1 stykkiStaðgengill
Þessi teikning býr til
Tengd Blueprint
Þessi blueprint deila þekkingu — tækni, efni eða meginreglur
CC0 opinbert ríki
Þessi teikning er gefin út undir CC0. Þér er frjálst að afrita, breyta, dreifa og nota þetta verk í hvaða tilgangi sem er, án þess að biðja um leyfi.
Studdu smiðinn með því að kaupa vörur í gegnum teikningu hans þar sem hann fær þóknun smiða sem seljendur ákvarða, eða búðu til nýja endurskoðun á þessari teikningu og tengdu hana sem tengingu í þinni eigin teikningu til að deila tekjum.