កិច្ចសហប្រតិបត្តិការ
សិល្បៈ
សម្រស់ និង សុខុមាលភាព
សិប្បកម្ម
វប្បធម៌ និង ប្រវត្តិសាស្ត្រ
ការកម្សាន្ត
បរិស្ថាន
ម្ហូប និង ភេសជ្ជៈ
វិស្វកម្មបញ្ច្រាស
វិទ្យាសាស្ត្រ
កីឡា
បច្ចេកវិទ្យា
ប្រដាប់ដែលស្លៀក
Craftsman Leather Billfold: Two Cardboard Patterns, Silk Lining and Saddle-Stitched Waxed Silk (Boy Mechanic, 1919)
Tex

បង្កើតដោយ

Tex

13. វិច្ឆិកា 2026FO
15
0
0
0
0

Craftsman Leather Billfold: Two Cardboard Patterns, Silk Lining and Saddle-Stitched Waxed Silk (Boy Mechanic, 1919)

Livingston Haviland's billfold from The Boy Mechanic, Book 3 (1919): two leather body parts cut to stiff-cardboard patterns (13-1/4 and 8-3/16 by 4-1/4 in), lined with skiver or silk moire, folded into two card pockets and a money compartment, glued, and hand-sewn with heavy waxed silk 3/16 in from the edges.
មធ្យម
About 1 day

ការណែនាំ

1

His patterns in centimetres

កំពុងផ្ទុកសៀវភៅ Jupyter…
2

Read The Boy Mechanic, Book 3

"The making of a billfold is easily within the range of an amateur in leather work, who will observe the instructions carefully." Seal, morocco, pigskin and ooze sheep are all satisfactory.
3

Cut the patterns and the leather

Cut two patterns of stiff cardboard (Fig. 1). Body part No. 1: 13-1/4 by 4-1/4 in, with fold lines at 2-1/2, 2-5/8, 3, 2-5/8 and 2-1/2 in, and each end (A, B) cut in with 1/2 in radius arcs, set in 1/4 in. Body part No. 2: 8-3/16 by 4-1/4 in, with fold lines at 2-19/32, 3 and 2-19/32 in. Lay each pattern on the leather and trim the leather even with it, guiding the knife with a metal straightedge, on a close-grained hardwood board or a piece of sheet zinc.

សម្ភារៈសម្រាប់ជំហាននេះ៖

ស្បែកជ្រូកសម្លាប់រួចស្បែកជ្រូកសម្លាប់រួច1 ដុំ
សន្លឹកគំរូធ្វើពីក្រដាសកាតុងសន្លឹកគំរូធ្វើពីក្រដាសកាតុង1 ដុំ

ឧបករណ៍ដែលត្រូវការ៖

ខ្មៅដៃខ្មៅដៃ
បន្ទាត់បន្ទាត់
គែមត្រង់គែមត្រង់
កាំបិតសិប្បកម្មកាំបិតសិប្បកម្ម
ក្តារឈើរឹងក្តារឈើរឹង
សន្លឹកស័ង្កសីសន្លឹកស័ង្កសី
4

Line the parts

Cut linings slightly larger than the patterns. Skiver is glued all over with a good, pliable leather glue that will not crack the leather; smooth it on gently without stretching, or the leather may buckle, and dry it under a light weight. Silk moire is glued with a thin stripe round the edges only, left to overhang, and trimmed off neatly when dry.

សម្ភារៈសម្រាប់ជំហាននេះ៖

ក្រណាត់សូត្រក្រណាត់សូត្រ1 ដុំ
កាវបិទស្បែកកាវបិទស្បែក1 ដុំ

ឧបករណ៍ដែលត្រូវការ៖

កន្ត្រៃកន្ត្រៃ
កាំបិតសិប្បកម្មកាំបិតសិប្បកម្ម
5

Glue and fold

Fold part No. 1 to form the back and the two card pockets. Apply stripes of glue as shown in Fig. 3, drop part No. 2 (the money compartment) into place, and fold the ends of No. 1 over on the dotted lines. Weight the billfold and let the glue dry.

សម្ភារៈសម្រាប់ជំហាននេះ៖

កាវបិទស្បែកកាវបិទស្បែក1 ដុំ

ឧបករណ៍ដែលត្រូវការ៖

ឧបករណ៍ឆ្លាក់ស្បែកឧបករណ៍ឆ្លាក់ស្បែក
6

Mark and punch the stitching

Draw a straight line with a blunt-point tool along the edges to be sewn, 3/16 in from them. Mark the stitch spacing for an inch on a strip of paper and transfer it along the line. Punch the holes on a pine board with a diamond-pointed awl held vertical (D); back the open ends with strips of cardboard while punching.

ឧបករណ៍ដែលត្រូវការ៖

ឧបករណ៍ឆ្លាក់ស្បែកឧបករណ៍ឆ្លាក់ស្បែក
បន្ទាត់បន្ទាត់
ដែកចោះដេរបាតដែកចោះដេរបាត
ក្តារឈើស្រល់ក្តារឈើស្រល់
សន្លឹកគំរូធ្វើពីក្រដាសកាតុងសន្លឹកគំរូធ្វើពីក្រដាសកាតុង
7

Sew and finish the edges

Sew with heavy waxed silk matching the leather, by hand or with the work clamped between two boards. Thread a needle on each end, start both from the right side (E), pass the needle from the first hole through the second (F) and, with the needles in position (G), continue this stitch. Tie the ends neatly. Trim the edges and tool them smooth with a suitable metal tool or rod, heated moderately, applying water with the fingertip.

សម្ភារៈសម្រាប់ជំហាននេះ៖

អំបោះសូត្រសម្រាប់ដេរអំបោះសូត្រសម្រាប់ដេរ1 ដុំ
ក្រមួនឃ្មុំក្រមួនឃ្មុំ1 ដុំ

ឧបករណ៍ដែលត្រូវការ៖

ម្ជុលដេរកែបពីរម្ជុលដេរកែបពីរ
កន្ត្រៃកន្ត្រៃ
កាំបិតសិប្បកម្មកាំបិតសិប្បកម្ម
ដែកថែបទន់មូលដែកថែបទន់មូល
8

Troubleshooting

Billfold troubleshooting.

Flow

Loading...
9

History and honest limits

From "A Craftsman Leather Billfold" by Livingston Haviland, in **The Boy Mechanic, Book 3**, Popular Mechanics, 1919 (Project Gutenberg 71856; checked on the archive.org scan boymechanic0003unse, pp. 446-447). He does not give the number of stitches to the inch or what waxes the silk (beeswax is ours). Pigskin is one of his four leathers. The tools and metric figures are ours.

សម្ភារៈ

6

ឧបករណ៍ចាំបាច់

13

CC0 សាធារណៈ

ប្លង់នេះត្រូវបានចេញផ្សាយក្រោម CC0។ អ្នកមានសិទ្ធិចម្លង កែប្រែ ចែកចាយ និងប្រើប្រាស់ដោយមិនចាំបាច់សុំអនុញ្ញាត។

គាំទ្រអ្នកបង្កើតដោយទិញផលិតផលតាមរយៈប្លង់របស់ពួកគេ ដែលពួកគេទទួលបាន កម្រៃជើងសារអ្នកបង្កើត កំណត់ដោយអ្នកលក់ ឬបង្កើតកំណែថ្មីនៃប្លង់នេះ ហើយបញ្ចូលជាការតភ្ជាប់ក្នុងប្លង់របស់អ្នកដើម្បីចែករំលែកចំណូល។

ការពិភាក្សា

(0)

ចូល ដើម្បីចូលរួមពិភាក្សា

កំពុងផ្ទុកមតិ...