예술
뷰티 및 웰니스
공예
문화 및 역사
엔터테인먼트
환경
음식 및 음료
역공학
과학
스포츠
기술
웨어러블
Glass Wool
Emma

작성자

Emma

22. 9월 2026SE
45
0
0
0
0

Glass Wool

Glass wool was made before the 1930s by blowing steam at a falling thread of molten glass, but by the time the glass reached the blast it had cooled too far to draw really fine fibres. Games Slayter at Owens-Illinois brought the blast right up to the bushing the glass leaves the furnace through, while it was still at furnace heat. **US 2,133,235**, "Method and apparatus for making glass wool", Slayter, assigned to Owens-Illinois, filed 11. November 1933, granted 11. October 1938. Its FIGURE 1 (the picture above) shows the furnace, the bushing, the steam blast and the wool piling onto a conveyor. The same work led to Owens-Corning Fiberglas in 1938. **You measure what it is for**: three jars of hot water - bare, in glass wool, in cotton wool - logged by an Arduino, and the cooling curves turned into heat-loss figures.
초급
2 hours

안내

1

Wire the logger

Probes' red to 5V, black to GND, data (yellow) together to D2, with a 4.7 kΩ resistor from D2 to 5V. Install the OneWire and DallasTemperature libraries. Warm each probe in your hand in turn to learn which index is which.
three_jar_cooling_logger.inocpp
// Three-jar cooling logger - batch 98, US 2,133,235
// Three DS18B20 probes share one data wire on D2 with a 4.7 k pull-up to 5V.
// Prints one CSV line every 30 s: seconds, then the three temperatures in C.
#include <OneWire.h>
#include <DallasTemperature.h>

OneWire bus(2);
DallasTemperature sensors(&bus);
const unsigned long PERIOD_MS = 30000;
unsigned long t0;

void setup() {
  Serial.begin(115200);
  sensors.begin();
  Serial.print(F("# sensors found: "));
  Serial.println(sensors.getDeviceCount());
  Serial.println(F("t_s,probe0_C,probe1_C,probe2_C"));
  t0 = millis();
}

void loop() {
  sensors.requestTemperatures();
  Serial.print((millis() - t0) / 1000);
  for (uint8_t i = 0; i < 3; i++) {
    Serial.print(',');
    Serial.print(sensors.getTempCByIndex(i), 2);
  }
  Serial.println();
  delay(PERIOD_MS);
}

이 단계의 재료:

DS18B20 온도 센서DS18B20 온도 센서3 개
저항 키트저항 키트1 키트
Dupont 점퍼 와이어 세트 (수-암)Dupont 점퍼 와이어 세트 (수-암)1 세트

필요한 도구:

Arduino Uno R3Arduino Uno R3
Breadboard - ClassicBreadboard - Classic
SparkFun Cerberus USB Cable - 1.8 meterSparkFun Cerberus USB Cable - 1.8 meter
2

Prepare three jars

Drill a 7 mm hole in each of three identical lids. Push a probe through each so its tip sits mid-jar. Seal the hole with tape.

이 단계의 재료:

뚜껑 있는 유리병뚜껑 있는 유리병3 개
마스킹 테이프마스킹 테이프1 롤

필요한 도구:

무선 드릴무선 드릴
드릴 비트 세트드릴 비트 세트
3

Wrap two of them

Gloves, long sleeves, mask, glasses. Put glass wool inside a plastic bag, then wrap jar 2 in it 30 mm thick all round and under, and tape. Wrap jar 3 the same way in cotton wool. Leave jar 1 bare.

이 단계의 재료:

글라스울 단열재글라스울 단열재1 롤
탈지면탈지면1 팩
비닐봉지비닐봉지4 개
마스킹 테이프마스킹 테이프1 롤

필요한 도구:

가죽 작업 장갑가죽 작업 장갑
방진 마스크방진 마스크
투명 보안경투명 보안경
가위가위
4

Fill and log

Boil water. Pour 500 ml into each jar, one after another, and close the lids. Start the serial monitor and log for 90 minutes. Note the room temperature.

필요한 도구:

유리 전기 주전자유리 전기 주전자
눈금 실린더눈금 실린더
5

Fit the curves

Jupyter 노트북 불러오는 중…
6

History & Context

**What the patent specifies:** a steam blast applied at the bushing itself, so the glass stream is drawn while still at furnace temperature, giving very fine wool. **Modern build (derived):** commercial glass-wool insulation, handled wrapped. Continuous glass filament for textiles and reinforcement followed from the same laboratory. Its limits: loose fibres irritate skin, eyes and lungs, so it is always handled covered, and like any fibrous insulation it loses most of its value when wet or compressed.
단계 6 - Image 1

재료

8

필요 도구

11

관련 블루프린트

이 블루프린트들은 지식을 공유합니다 — 기술, 재료 또는 원리

CC0 퍼블릭 도메인

이 블루프린트는 CC0로 공개되었습니다. 어떤 목적으로든 자유롭게 복사, 수정, 배포 및 사용할 수 있습니다.

제품 구매를 통해 메이커를 지원하세요. 판매자가 설정한 메이커 커미션 을 받거나, 이 블루프린트의 새로운 반복을 만들어 연결로 포함시킬 수 있습니다.

토론

(0)

로그인 하여 토론에 참여하세요

댓글 로딩 중...