ศิลปะ
ความงามและสุขภาพ
งานฝีมือ
วัฒนธรรมและประวัติศาสตร์
ความบันเทิง
สิ่งแวดล้อม
อาหารและเครื่องดื่ม
อนาคตสีเขียว
วิศวกรรมย้อนรอย
วิทยาศาสตร์
กีฬา
เทคโนโลยี
อุปกรณ์สวมใส่
Making a Dizi — The Chinese Bamboo Flute with a Buzzing Membrane
Woody

สร้างโดย

Woody

3. กรกฎาคม 2026NO
1
0
0
0
0

Making a Dizi — The Chinese Bamboo Flute with a Buzzing Membrane

Build a dizi, the Chinese transverse bamboo flute with a secret: a thin membrane (the dimo) stretched over an extra hole that buzzes and gives the flute its bright, reedy voice. Cut the blowing hole, the membrane hole and the finger holes, glue the dimo, and play. A buildable school project in the side-blown flute and the buzzing membrane.
เริ่มต้น
45 minutes

คำแนะนำ

1

A flute with a buzz

The dizi is a Chinese bamboo flute you blow across from the side. Its secret is a thin membrane over an extra hole that buzzes, giving the dizi its bright, reedy, singing voice.
2

Choose a bamboo tube

Pick a straight bamboo tube about 45 cm long and a thumb thick, with a solid node left near one end to seal it. The far end stays open.

วัสดุสำหรับขั้นตอนนี้:

BambooBamboo1 ชิ้น
3

Clear the bore

Push out the inner pith and nodes so the tube is clear — but keep the one node near the top sealed, just behind where the blowing hole will go.

เครื่องมือที่ต้องใช้:

AwlAwl
4

Cut the blowing hole

A couple of centimetres below the sealed node, cut a round blowing hole. You blow ACROSS this hole from the side, not into the end of the tube.

เครื่องมือที่ต้องใช้:

Sloyd Carving KnifeSloyd Carving Knife
5

Cut the membrane hole

A little below the blowing hole, cut a second round hole — the membrane hole. This one is the dizi's secret and carries the buzzing dimo.

เครื่องมือที่ต้องใช้:

Sloyd Carving KnifeSloyd Carving Knife
6

Cut the six finger holes

Further down the tube, cut six finger holes in a line, spaced to fall comfortably under your fingers.

เครื่องมือที่ต้องใช้:

AwlAwl
7

Cut the end holes

Near the open end, cut one or two extra holes. These set the lowest note and, on real dizi, hold the hanging tassels.

เครื่องมือที่ต้องใช้:

Sloyd Carving KnifeSloyd Carving Knife
8

Prepare the dimo membrane

Take a small piece of thin dimo membrane — traditionally the inner skin of a reed. Very thin tissue or an onion skin will also buzz.

วัสดุสำหรับขั้นตอนนี้:

Dizi Membrane (Dimo)Dizi Membrane (Dimo)1 ชิ้น
9

Glue the membrane

Brush a little garlic juice or weak glue around the membrane hole and lay the dimo over it with TINY wrinkles across the grain. The wrinkles are what make it buzz.
10

Test the buzz

Blow across the blowing hole. The membrane trembles and adds a bright, buzzing shimmer to the note — that reedy rasp is the true voice of the dizi.
11

Play the scale

Cover all six finger holes for the lowest note and lift them one by one to climb. Blow harder to overblow into the higher register.
12

Tune the buzz

Press the wrinkles tighter for a mellow tone, or loosen them for a brighter, louder buzz. A fresh, taut dimo sings; a slack one rattles.
13

Compendium — the membrane flute

The dizi is a transverse, or side-blown, flute: you blow across the blowing hole so the ribbon of air splits on its edge and sets the air column inside vibrating — the same edge-tone that sounds a Western flute, and quite unlike the end-blown recorder or panpipe. The finger holes change the pitch in the usual way, by shortening the vibrating air column when you open them. What makes the dizi unique is the dimo: a thin membrane stretched over its own hole. When the air column vibrates it drives the membrane too, and the lightly wrinkled membrane buzzes at many frequencies at once, pouring extra high harmonics into every note — a bright, reedy shimmer. This is a mirliton: a membrane that buzzes in sympathy with a sound, exactly the principle of a kazoo or a comb-and-paper. Bamboo flutes are ancient in China — the bone flutes of Jiahu are about 9,000 years old — and the membrane dizi became the standard voice of Chinese music over the last thousand years. Tighten the dimo for a soft tone or loosen it for a rasp; it is the one part of the flute you can re-tune every time you play.

วัสดุ

2
  • 1 ชิ้น
    ตัวยึดตำแหน่ง
  • 1 ชิ้น
    ตัวยึดตำแหน่ง

เครื่องมือที่จำเป็น

2

You can swap these in

Can't get one of the materials? Swap it for an equivalent — these work just as well.

บลูพริ้นท์ที่เกี่ยวข้อง

บลูพริ้นท์เหล่านี้แบ่งปันความรู้ — เทคนิค วัสดุ หรือหลักการ

CC0 สาธารณสมบัติ

พิมพ์เขียวนี้เผยแพร่ภายใต้ CC0 คุณสามารถคัดลอก แก้ไข แจกจ่าย และใช้งานผลงานนี้เพื่อวัตถุประสงค์ใดก็ได้ โดยไม่ต้องขออนุญาต

สนับสนุนเมกเกอร์โดยซื้อสินค้าผ่านพิมพ์เขียวของพวกเขา ซึ่งพวกเขาจะได้รับ ค่าคอมมิชชันเมกเกอร์ ที่ผู้ขายกำหนด หรือสร้างเวอร์ชันใหม่ของพิมพ์เขียวนี้และรวมเป็นการเชื่อมต่อในพิมพ์เขียวของคุณเพื่อแบ่งรายได้

การสนทนา

(0)

เข้าสู่ระบบ เพื่อร่วมการสนทนา

กำลังโหลดความคิดเห็น...